Wireless

I'm going through this doc to tune our WLCs at the advice of our mobility sales engineer. 3 Steps to Tuning a Cisco WLAN Controller From Default Settings In this doc it recommends making the 802.11a/n/ac 12 & 24Mbps data rates mandatory.  We currentl...

Hi, I am facing some problem to join my access point(AIR-CAP1702I-C-K9 & AIR-CAP1702I-D-K9) in 2504 WLC. I have already configure as below: 1. Add two Country code for C(PK) & D (IN) 2. Management Interface IP address: 192.168.1.10     Subnet: 255.25...

Hi, I've been trying to configure 4 aironet 1852 APs with a 2504 wireless controler and not having any luck.This is not my area of expertise(I usually work with telephony) and english is not my first language, please bear with me. All the devices are...

Hi Would there be an issue with Bonjour Gateway if services were being connected to one SSID and clients another but they both used the same interface? Also, the vWLC APs are in flexconnect mode, centrally switched. AP multicast mode is UNicast.  Iss...

Hello All,  Can someone give me some guidance as to how I can enable smartcard login for my admin nodes. I'm trying to authenticate administrator using their PIV cards. Is this even possible?. Cheers!

Hi all I hope you can help me  I have a faulty Cisco AIR-LAP1143N-E-K9 wireless access point that I got second hand and I was wondering if there is any way to fix it before I try to send it back. The error I think I am getting is when trying to reset...

Hi, I moved one of my AP 1242 AG to LAP IOS. Now when i try to move to Autonomous IOS i am facing problem. I used TFTP server and i observed unable to open the file in AP. Pease suggest me is there any other way to move to autonomous AP.

Dear Folks, I am currently deploying Cisco 1532e-UXk9 APs which were not primed and provisioned where priming is not possible in our country (Bad Luck). I was wondering if i could get a primed and provisioned AP Ios and upgrade those APs to a new ios...

Hi everybody,  Does any body knows how many clients does the "p" series of the 3700 / 3800 AP can support without service degradation? an aproximate or an avergae? Regards!

Dear 's  i have a CMX virtual version 10.2.3 and Cisco WLC 5520 , i import the MAP and exported by using prime and i added the WLC and it give active  but now i am so confused cause i cannot find a helpful  document about this subject so my Question ...