Wireless

Hi,We are running a full cisco wireless solution (MSE, WCS, WLC....)On the WCS we are receiving random 'Netstumber Detected' events which I suspect are being detected by the IDS in the WCS.Currently email alerting is configured for all critical event...

I have 5 new 2602i-n APs that I am getting a "Lwapp join request rejected" error in the AP Join log of the controller.  I have other 2602s working just fine, and I have other N radios working just fine.  I have moved the APs to 2 other controllers, v...

Hi ,I have to validate RRM Feature for CCX Clients ,for that we have to use following hidden command : " test aprm rmrq client xxxx.xxxx.xxxx dot11radio 0 clientreq.txt " ,but if run this hidden command  then it is giving "Unrecognized Command" .Plea...

Is a monitor mode AP required on the network for switch port tracing to work correctly?Reason I ask is when running a report for OFF network (off wireless) APs, none are coming up.I'm thinking a monitor mode AP might be the missing piece to the equat...

I have a customer looking to use the AIR-ANT2440NV-R= bell shaped MIMO antenna on an older 1242AP.  This is to essentially increase signal coverage using hardware already available.They only need the 2.4GHz "G" coverage which this antenna would look ...

Good Morning everyone,I'm trying to get a 5508 (foreign) and a 2504 (anchor) on 7.5 to work with AirPlay.   It's a single SSID/subnet, nothing to fancy other then the anchor.  The anchor is providing the wlan for internet access, while the clients (i...

Hi,See attached imaget to see how things are configured today. We also want to have local switching on Guest wlan in the remote location but have so far been unsuccessful. My knowledge regarding anchor controllers is limited, so I was wondering what ...

Hi,As of now I have our RADIUS server defined in both the WLAN and Flexconnect group. Do I need to define it in both? Which one is primarily used for authentication of users?Regards,Philip

My WLC mode is 5508, code is 7.4.110.0(7.0.230.0 upgrade to 7.4.110.0)One SSID needs web auth,but when the clients connected to this SSID,it can redirect to web auth page, after user login ,login page pop up again. this problem is not happened before...