Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Hello Only autonomous APs in deployment installed base has AP1240AG. New AP are AP1602E Need to support VoIP with CP7926G terminals. So FastRoaming and WDS would be needed/desired. From Config guide: One of the pre-requisites of WDS is that all APs n...

I have the following setup. WLAN consisting of Cisco 3602 Access Points, a WLC, running on a Cisco LAN. I have Ubiquity Air Routers running in AP mode that acts as Bridges, to which a PLC & Workstation is connected. With no data running over the netw...

jacovr by • Level 2
  • 424 Views
  • 0 replies
  • 0 Helpful votes

Dear all, currently I have a WLC 2112 / IOS:5.2.193.0 (up and running) and 5 AP 1131AG / IOS 12.4(18a)JA2  (up and running) 1 AP AP1230B (NEW) My questinon is: 1. Is that possible to have a mixed AP enviroment with this 2 diff. AP's? 2. If yes, what ...

I need suggestion from wireless expert on below matter. There two WISM controller for Guest Network in which 210 APS are connected(1040 series) And one 5760 controller is used for Admin Network in which 96 APS are Connected (2602 series) How can we i...

hi, I have few cisco aironet accesspoints, that I converted to autonomous ap.  Is there any ios command that i use to find out if the AP 1. 11ac or 11n 2. TXxRX streams 2x2 or 3x3  I found out one way is to give following commands #int dot11 1 # spee...

yuvaraj02 by • Community Member
  • 762 Views
  • 2 replies
  • 0 Helpful votes

1) Does WLC support SKC + OKC on same WLAN simultaneously? 2) Documentation of 802.11r (FT) is contradictory: Restrictions for 802.11r Fast Transition • This feature is not supported on access points in FlexConnect mode.• For the access points in Fle...

My AP 1830 is located at branch office but I do not want to deploy it in express mobility mode. Can my AP 1830 operate as local mode and communicate with my centralized controller at HQ and DR? My customer do not want distribute mobility express cont...

Hello, I want to install a wireless bridge between 2 buildings. I think i want to choice Aironet 1532E with antenna 2.4 Ghz 13-dBi (AIR-ANT2413P2M-N). And i would like to know what is the maximum range between my two points ? Thanks You.

ntouzet31 by • Community Member
  • 1603 Views
  • 6 replies
  • 0 Helpful votes