Wireless

Team, Need a a technical support that says that the AP 2702 works fine with the power injector 5, eventhough in the datasheet the power injector recommended is the power injector 4. I have tested it, and works okey. Thnks!

Hi guys, i have a 1602 Aps in my organisation and 5508 wlc, the problem is that am facing weak signal coverage , 3 apS ARE INSTALLED AT A HEIGHT OF 30 FT due to which even if am standing beneath the ap only one signal bar its displaying. other aps ar...

Hi,Can someone give me some documentation about the area coverage for Cisco Aironet 1700/2700/3700? ThanksSamuel

Trying to narrow down possibilities for an issue with 2504 WLC and airprint/time capsule.  Initially got the WLC unit in and 8.1 loaded.  Discovered nobody could use airprint.  Ran across a posting about cisco dropping some portion of support for bon...

We need a at least 20 ft extension cable for antenna 3G-ANTM-OUT-OM used on Cisco 819 router. Cisco link below shows two types of cables: LMR400 and LMR240. Which one should I buy for outdoor use? http://www.cisco.com/c/en/us/products/collateral/rout...

Dear All, we've installed some Cisco 1572 Outdoor APs but the signal bars are not consistent on both laptops and mobile phones and we're facing this problem for the users who are nearly in 10 meters of radius from the AP. please advise  BR

Hi How to enable band steering in wlc?

I was conducting a study on spectrum utilization around my managed network (100 LAP1142N APs controlled by a 4404 WLC). I gathered statistics of rogue APs via SNMP (object bsnRogueAPChannel [1]) and found that many rogue APs were detected in channel ...

Based on the 7 point recommendation post to "How to get your 792x wireless phones performing reliably" it recommends setting power levels in all 5GHz deployments but the very densest ones, to simply set a power level of 1 (maximum). Does this impact ...

Hi everybody, i have new access point 3702E with directional anntena, i think it needs power more than 15.4 the access switch 2960x 24 370W, that's mean each port 15.4. my question is have i go with PWRINJR4 or  PWRINJR5 to increase the power.

we have a project that is using 1-1532I in Autonomous root bridge mode to the local network. Then there are two more Autonomous 1532I in bridge mode that have video surveillance cameras connected to them. Every thing worked fine for 3 weeks.however t...

Hello..Need to connect an outdoor wireless AP (AIR-CAP1532I-A-K9) to a WS-C2960+PC-L PoE switch...should I also use a power injector (AIR-PWRINJ1500-2= ) as the PoE switch will not provide sufficient power for outdoor AP..

We swapped out 3502s for Meraki MR32 and aeroscout tags for temperature monitoring stopped working. Meraki TAC did not have much of an insight. Hopefully someone on here has had that experience and can offer some suggestions. We have backed out and r...