Wireless

Customer purchased a HA pair of 5508 controllers.Is there a way via a purchase and conversion process to change the secondary 5508 to be full 5508 so that they can both be active and be part of a larger N+1 WLC environment? Also can a HA pair be part...

need an access Point cisco support 25 users but out of N Category ?

Hi,I have a cisco 1602E connected to my 3850 WLC.  The 1602E LWAP has joined the WLC and i can control the LWAP via the 3850 wireless gui.However, I cannot see the SSID being transmitted - all settings to transmit the SSID are good.The issue lies (I ...

Hi All, How to do factory reset Cisco 3700 series controller based access point ? AP model : AIR-CAP3720I-D-K9 (Cisco Aironet 3700 Series 802.11 ac Dual Band Access Point )  Regards,Nidhin Chandran

I intentionally broke my AP to see if i can recover it, but i'm having some issues, how do I upload the IOS from the boot rommon? ap: ?           ? -- Present list of available commands         arp -- Show arp table or arp-resolve an address         ...

Hello all,I would like to add some new AIR-CAP2602E-E-K9 on a WLC 2504 version 7.4.110.0. The subnet that was assigned for the management of WLC and AP is full, and the subnet mask cannot be changed since it will influence other subnets as well. It w...

Just got a hold of a 2504-5 WLC unit and before it arrives I wanted to do a bit of config work.Currently have 2x 3502e, 1x 3502i, 2x 3602e all set in auto modeThe issue I'm hung up on in setting the dhcp options for multiple vendor classes.but I supp...

In my client network suddenly few users are not able to connect to Cooperate SSID or suddenly the connection will lost. I have pulled the debug output from the controller. I suspect its authentication issue but not sure and dont know how to fix it.. ...

The AP has lost it's firmware . Have file c1130-k9w7-tar.123-8.JEA3.tar. I am trying to get this file into the file system of the AP.  The problem is it does not seem to have the commands that I need. these are the commands that I have access to:ap: ...

It is required to access the device for the first time to put the device to operate in standalone mode.

Hello, everything is in the tiltle:I have aWLC5508, and i need to change the default credentials, i do not have access to those AP anymore so i  can not have a cable console to it.The only access i have is thru my WLC.Is there a way to change the Use...

I just installed a aeronaut 2702i with 2504 controller. The AP seems to be registered ok, status on the controller displays registered and up. I can connect to the newly created SSID. However the LED on the AP is still cycling red-green-off. I read i...