Wireless

I am using Cisco prime 2.2.0 versionI get lot of Security Penetration alerts and DOS alerts as critical.I donot want to acknowledge this and Can anyone please let me know what needs to be done how to avoid these kind of alerts? Thanks,Abi

We have a 4402 that is currently using machine authentication for radius.  Does anyone know how we'd switch it to use user authentication?  

have installed AIR-CAP2702I-K-K9 with power injector and WLC.AP is power on.INjector has AC POWER & AP POWER LED is on.But switch port state is not connected. Not ethernet cable problem.Power injector is fault?

Our network has different vlans One ubtrusted VLAN was used as Wifi network.In this Vlan was a Apple airport whice was used as accesspoint for multiple wifi devices.There are  also 2 wifi printer that support wifi direct. After changing the airport b...

Im configuring a 5508 controller on a layer 2 network. Im only able to access the controller through the service port and not through the management interface. I can see the controller on the CDP neighbour table on the switch that it connects too. I ...

Hi Cisco, We purchased two "WAP4410N" units , we kept for production environment but it's frequently disconnects and network is very unstable, if suppose connected to this device and try pinging any of the server, i am getting packet loss and very ra...

HiI have a issue about SNMP Trap Controls page Client is WLC 8510 in page client is enable auto but after i Change config  I apply config now but not work .   

I just got a new cisco EPC3925 wireless modem and I would like to know how to use the USB port, and what to use it for. Thank you ---Posted by WebUser Patrick Ciantar

One of my housemates has had to borrow my wifi adapter to connectto UPC BB in my house which uses a cisco epc2425 cable router/modem.Recently found a Netopia 2247. Is it possible to setup the 2247 asa wifi repeater so my housemate can simply connect ...

Hello, I am in thailand and unfortuanly the provider proivide us oldie hardware... A Cisco EPC2325...Before with my WAG320N all is perfect between WAN and my NAS. I have NAS 192.168.1.200 with ftp access port 21. Normally in WAG320N I just specify th...

I have been told from Cisco engineers different results regarding WLC 5508 ports should be tag or untag situations.  One think I know, might not be 100% correct, isIf WLC 5508 port is tag then the switch port should be configured as a trunk port.If W...

Hello, On my WLAN Controller i have two LobbyAdmin accounts and 2 WLAN's with web-auth.When i make a user account on my LobbyAdmin1 account on WLAN1, i can also see this account when i login with my LobbyAdmin2 account.Is it possible to seperate thes...

Hi,I have a wireless access point, how can i connect it to a layer 2 switch thorough it's layer 3 interface.what configurations do I need on wireless access point and layer 2 switch?If I want to connect this access point to a layer 3 port on a layer ...

Hi , Can you explain four way hand shake step by step  in wap2 enterprise ? I read some document but I dont understand exactly  why is derive PMK , PTK ,  PGK . isn't   An hacker  capture this value . Help please