Wireless

Hi All,I found that i have to backup 150GB size application file before reimaging to 2.2. But if i take over the network, it takes very long time (in days i guess -for 1 hour, only 500 mb it transfers). Is there any option to speed this process..? Ca...

Hi All,Working on a wireless solution for the four main satellite sites.UKAmericaAsiaEurope My ask is what's the best solution for guest wireless access? My thoughts are 5760 (UK) and 3850's accompanied by ISE (Admin in the UK with policy personas at...

Hello,I installed a WAP561 at my office, the two radios are activate and I defined 3 VAP, 2 "public" for visitors and one private for employesI defined Scheduler : enable, Status Enabled/Reason:IsActive,I defined a profil Weekday from 8am to 7:30pmIn...

Hi.. i have running cisco vWLC controller in my location A, its working perfectly here. Now i have another location B where i have APs registered with controller in location A. I have created another WLAN and set location B dhcp server assign locatio...

Hey guys, I have this problem: When a user logs in using Layer 3 on an Access Point, the user goes away for a few minutes, when the user comes back the AP asks to login again. I tried enabling Sleeping Clients on Layer and gave them a day, but it's s...

Hi guys, we are working with MSE from some time and few days ago an interesting issue appeared.Do you know what is the correlation between floorNumber and floorRefId?As we receive info about the maps from MSE API, it returns the value of the floor 'f...

Hello,to create a GSM profile, we need a "username", "password" and un "APN" provided by the Service Prodiver, if you have more than one router Cisco  819, should we  have a "usernale" and "password" for eatch router, or the same "username" and "pass...

Is it possible to do the following on a 5508 WLCI have a management and one other VLAN trunked to a switch, say 10 and 20 I have an interface configured on the controller as VLAN 10 with an IP address of 192.168.1.1/24 I have a management interface o...

One WLC is serving multiple sites with different QoS requirements. So we have multiple WLAN profiles with the same SSID, L2 policy open. All of them are anchored at the same anchor WLC. There are the same WLAN profiles with the same IDs at the anchor...

HelloIt is possible to configure SNMP in an AP lightweight with WLC 5508 to get some information with snmpwalk as a AP Serial number? Thanks for your help Regards

Dears,We have a wireless infrastructure here using a WLC5508, and APs 2602i, 2602e and 3702e.Some users complain about signal strength as per below...Sometimes they really get a low signal... 2 or 3 bars..... When I saw at Controller,even when they a...

I am trying to find information on whether it is possible to setup bridging between two lightweight AIR-CAP1532E-A-K9 units and NOT have the traffic be sent back to the WLC via capwap tunnel.  My goal if possible is to keep the traffic local to the A...