Wireless

I'm trying to create a b/g/n RF Profile and I keep getting this error.Band Select client RSSI out of valid range (-90 to -20)I've set it at -90, -80, -50, & -20  same error. Is this a bug?5508WLC code version 7.6.120.0 

Hi All, I got an old cisco WLC 2106 I would like to try to get running. It seems RAM memory has been removed.Any ideas what is the right memory, is there any cheap replacement?Thanks

Relatively simple question, I am just having a tough time figuring out analyze the data. Anyway... We use the Tamograph Wireless Survey utility and with this utility you are able to perform passive, predictive and active surveys. With the passive\pre...

Hi all,I want / need to upgrade the FUS on my AP SSO 7.4.100.0 cluster.How to do this?I can't find instructions on how to upgrade in AP SSO mode, nothing in, in the release notes.ThanksWillem

HiI'm trying to test multiple SSIDs in the lab and I'm battling to get only one SSID up and running, I have attached the configuration and the url that I read to configure the router but for some reason I'm winning. Please assist with viewing my conf...

Hi,Is it possible to push the new IOS firmware image to lwapp or capwap access points via TFTP Scope Option in the DHCP Server either through IOS commands in Switch or Router or through Windows Server.I tried the below option, where the AP is getting...

I have a Cisco MBR that I use for a mobile requirement. My setup is small (fits in a small backpack) and I get about 4 hours of use on battery with one PoE device connected. I currently use a CradlePoint product that is PoE powered and lets me plug a...

Hi,Am facing problem with Flexconnect with guest user. My scenario is i have local DHCP at remote site for guest but i want them to authenticate through central WLC.Am using Layer 3 web authentication. also the web authentication page is not popping ...

Hi All, can anyone help me sort out the issue with the wireless connectivity to the Sonos speakers and the HP wireless printers.except these two all other users are able to connect to the wireless network and working perfectly,I had a doubt on multic...

Recently I replaced my ISP equipment with a Linksys WRT 1900AC wireless router.  When I did this I lost connection to my LAP1142 that acts as a repeater. I can assign a static IP address of 10.0.0.3 255.0.0.0 and use the GUI interface, but when I sel...

I have just purchase a Cisco 2504 along with two 2702i and one 1702i. The WLC works fine with both 2702i. Unfortunately, it won't locate the 1702i. I have just see that the problem could be that the 2504 is running software 7.6.120.0 and that I shoul...

Hello guys, Enable the option to log the packets matching the ACLCSCtq05396DescriptionSymptom:ACLs on the WLC do not have the option to log the packets being denied/permittedConditions:In the event that we need to see the packets taking the counter h...