Wireless

We have a wireless controller with 15 access points(AIR-CAP2702i-K9). They were all up & working fine until we had a power outage. After the power came back up, they all came back up but 3 of the access points will not accept any clients. I have re-c...

Hello EveroneI'm using the Cisco Aironet 1140 Access Point.Some clients connecting to the 1140 are being issued IP Addresses in the169.254.0.0 range while others on the same AP are 10.0.0.0 range, which is what they should be. I know Microsoft client...

What I am trying to configure is Mobility Groups.My understanding is that this will allow AP to successfully register and fail over over seamlessly if any of the WLC had to fail ?It could be I am confusing two things into one  & I am totally confused...

Hello All,Here is a simple question...Its possible to link a WLC2100 running release 7.0.250.0 and a AP Cisco OEAP 600 Series? It looks like is possible but I would like to confirm if someone had try this before... thank you. Dan

Can anyone tell me if there are any differences in ordering products (access points) for Australia?  Should I use difference part numbers other than what I would use for the US?  Also are there any differences in 2.4 or 5ghz channels? Thanks for the ...

This issue is happening with six WAP4410N that are using POE and home-run to the same switch. The issue has happened with a different modem, different router and with the most up-to-date WAP firmware. The WAPs all have the same SSID, but issue also h...

Is there a simple way to script using either a terminal client (putty, teraterm, etc.) or Prime Infrastructure whereby I could set up a set of commands to be run at a certain interval? I want to conduct some client testing roaming across a site whils...

We are using ACS and WLC for wireless client authentications, The issue here is with single user, His credentials are not working in his laptop but they are working in other devices. The interesting part is other user credentials are working in his l...

I feed the MAC in the WLC as the MAC filtering is enabled however, I have seen without removing the mac the users mac get deleted. Any such experience Or solution.

Hello everyone,First at all, i apologize for my english, i'm trying my best here I'm posting here because i dont know much in WIFI Networking, an material selection. I need to change all access point in a warehouse. I have many rooms, but i dont knwo...

Hi All,Today i am facing issue with mobility group. i checked and found  control and data path is down on foreign controller.I am able to ping anchor controller. Required ports are open on firewall but mping and eping fails. Any idea whats wrong. On ...

Hi,      I am struggling / looking for a solution to have 2 different subnets on different frequency bands.  For example:  Is there a way to assign a subnet to the 2.4 band and a different subnet to the 5.0 band?  Maybe someone can give me an example...

Is there a way to create an ap group in cisco prime 2.0 so that I can select more than 1000 APs for a wireless template?

Customer currently has a Cisco 5500 WLAN controller at one of our datacenters. They want to add a WLAN controller as redundancy at their local site which shall be used as a secondary failover controller. This site is reachable over VPN. Which redunda...