Wireless

On the site (or foreign) WLC, I am receiving the following message in its message logs:*mmListen: Nov 03 22:46:36.954: #MM-3-PING_RESPONSE_DROPPED: mm_ping.c:378 Drop mobility ping reply from 137.183.242.149. Expected reply from 0.0.0.0. bogus reply....

I have a setup with 2504 and 3x 1532E in the ETSI domain. I noticed to my surprise that I cannot use dynamic (Auto-RF) for the channel selection on my 1532sfrom the WLC GUI (using 7.6.130) I have to manually select channels and power level. Using glo...

Hi Just wondered if anyone had noticed this with an upgrade to 7.6.130.0 and configuring HA SSO.Out of 44 AP's we had 6 that took a long time to join (2 hours). These were 1240 and 1130's. (I only noticed after the code upgrade and HA config)I tried ...

Good morning. We are looking for the product to replace our freeradius servers, and we have the following questions for Cisco ISE: 1. We want to use one SSID for all clients, and use ISE to separate the different roles (student, employee, faculty, gu...

Hello,I've 5508 WLC and adding a new 5760..I know, it's possible for this 2 to be in the N+1 model (version 7.6)If the 5508 or 5760 goest down, the AP previously associated to the failure controler, need to re-download the image to join the active co...

We have a wlc connected to a core switch.At the core switch have configured 3 vlans (vlan management, vlan for wireless network users, and to vlan access-point).At a remote site, we have another core switch where there are 3 other vlans which serve t...

Hi guys.As you know, in order to improve Wi-Fi location accuracy, we can apply our RF calibration model. I have a problem here, it is impossible to calibrate.I'm using:WLC 7.6.100.0;MSE 7.6.100.0;PI-VA-1.4.0.45-small.I have a client with Intel(R) Cen...

Hello, I have an Aironet AP1242 access point with which I have a problem. I can not accept the settings in the web interface. As soon as I click the "Apply" button it does not take into account the new settings. Do you have an idea to solve my proble...

I'm trying to get a cert loaded on my 5508 WLC running 7.6.130.0 so when a Web-Auth users tries to authenticate they don't get the SSL cert error.In the document "Generate CSR for Third−Party Certificates andDownload Chained Certificates to the WLC"D...

Hi AllWe have configured 2921 router, CME 9.1 and  ip phone 6921 all phone is registered  and every thing is working fine . But the some phone is not showing Missed call history  Ip phone firmware version :  cmterm-69xx-sccp.9-1-1-0 And one more ques...

We have 5 Cisco Aironet 1100 wireless access points and we are having huge problems in the last few days with them disconnecting some mobile barcode scanners that we have.We have two Aironet's in the top of the factory which work fine and 3 down the ...

On WLC5508 with 7.6.110.0 image, what could be the reason for MAP AIR-CAP1552SA to drop off from its RAP for 7 hours after 15 days of working? Apparently, the MAP joined back after seven hours with following messages below. (I have obfuscated actual ...