Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 4, 2025 through Friday, August 15, 2025. Our colleagues Saikat Nandy and Parithosh Vema will be waiting to assist you ...
Forum Posts
Resolved! Wireless guests unable to pass traffic
Hi Folks,This is a bit of an odd one that got me scratching my head, so hopefully the collective can help!We have a wireless deployment that spans multiple sites, the WLC's are located in Central Data Centres and we provide two SSIDs, one for our cor...
Hi everyone,my customer has an AIR-WLC4402-12-K9 using 12 access point with it, and they would like to increase the number of APs in use. Is there an upgrade option for 25? I couldn't find anything, but I suppose the hardware is the same, it's the so...
Hi all,I wan to use cisco 600 AP without wireless controller, just as a simple router or relay to get dhcp from dhcp server. I need help for how to configure it?
Hi All,We are expereincing some strange problems.1. One particular SSID's is appearing very low single strength & rest 2 SSID's are having good single strength from out of 3 SSID's advertised in one LAP.2. Another issue is one of the particular SSID ...
I am testing out using anyconnect network manager to manage our wireless network connections. I have anyconnect installed on my laptop and I have also downloaded the standalone profile editor. I have went through the editor and setup the networks t...
Hello.I have problem with login to AP in Cisco 881GW.I have in running-config default config with memory on flash this router: dir flash: cpc-8xxx.cfg.I write in EXEC mode: service-module wlan-ap0 sessionthen i must put login and password to AP.I wri...
Hi Guys,We're in the process of upgrading our old WLC Controller to a new vWLC Controller and I'm wondering if there is a way to transfer the existing WLC Cert to the vWLC and have both working at the same time? I need them to both work with the sam...
Resolved! MSE 7.5
Hello,Does anyone know how to upgrade license from MSE 7.3 to MSE 7.5 or we need to buy new ones?Thank you.
Current deployment consists of 16 WISM1s running 7.0.240.0 with ~ 1600 APs (predominately 1242s with some 1131 and even 1231s mixed in). Healthcare environment running multiple clinical applications (fusion pumps, IVs, etc), as well as VoFi, Vocera, ...
Resolved! WLC 4404 brick, what can i do?
Hello!Yesterday's power off. After turning on the controller wlc 4404 does not boot.On the console, we get the following:Net: PHY DEVICE : Found Intel LXT971A PHY at 0x01FEC ETHERNETIDE: Bus 0: OK Device 0: not available Device 1: not availableB...
Hi,I have a mesh network consisting of about 30 MAPs and 10 RAPs(1552E), which are controlled by a 5508. The area which needs to be covered is mainly consisting of tents.The problem is, this area is overcrowded by access points which interfere with o...
Hi All, I am facing follwing issue with Cisco WLC 2106 controller and the ios is 4.2.130. But controller is well configured and all 802.11g clients are accessing. Ap's interface 802.11b operational status down base mac add cause: admin configured.An...
Hello,Can the 2500 controller be used as anchor controller for a small WLAN ?If not, what is the smallest/cheapest controller that can be used as Anchor ?regards,GN
Resolved! WIFI Asking for Username and Password
After a building power outage our wireless network is asking for a username and password to connect to the wifi, does anyone know how to disable the username and only have it ask for the password?Our wireless is a Cisco 2106 with 4 access points.Than...
Hello Community,i would like to know if Cisco 881G+7-K9 Router with its included MC8705 3G modem is compatible with german carriers like vodafone and t-mobile. In Datasheets I couldn't find a statement regarding germany. Thanks.Best RegardsBenjamin
