Wireless

Hi ,  Is it possible to only enable 802.11g on my cisco aironet 1600 series ? I don't want N in there. many thanks

Hello all,At our home/ office we have four AP121 clustered together as one. Every now and then our connected clients (iphone, ipad, macbook, windows tablets and laptops, …) loose the connection with the wireless and then we have to reconnect again. T...

Hi, i would like to know if i could use hte cisco 3850 as a pass through to register with cisco 5508 at our main site. at the moment i can see the AP registering to cisco 3850 and not 5508. if i plug in the ap to a csico 2960 will connect to 5508 ?al...

We have AIR-CT5508-K9 WLC's running with IOS Code 7.4.110.0.We are adding new authentication servers to around 550 WLC's.While adding new servers to WLAN's we disable the WLAN and enable after adding I would like know SNMP OID to check the status of ...

Hey....As the title suggests, I am having problems deleting floors and buildings from the map section of Cisco Prime. I screwed up while putting the map files in, and cannot remove them... it just times out. The only solution I have come close to fin...

hi all, When I tried to configure CMX on my MSE after adding the license  i follow these steps: Choose Mobile Concierge Service > CMX Dashboard Configuration.Choose the Location MSE that the CMX Dashboard MSE gets the maps and location data from. It ...

Hi all,In short, APs will join the controller immediately using the recovery image, but once it downloads 7.6.100 and reboots, it either cannot join the controller or will take up to 40 minutes. The AP is in local mode. The AP 1040 eventually joined ...

I know that the WLCCA tool isn't officially supported, but I for one would love to see a webinar where we are walked through some of the tricks and tips to diagnosing RF issues with this tool.  I know there are some WLCCA gurus out there, and would l...

Hey guys, what is the Cisco replacement path to WCS? We just upgraded our wireless controller and it appears WCS has some comparability issues.

 Hi Everyone, I have issue going on at our site.Users when they connect to WLC 2100  and get IP address and when they use the Remote VPN client they get connected to VPN but unable toaccess the internet sites and internal resources. Same users when t...

 Hi Everyone, On Cisco WLC 2100 when user try to auth via Radius they get errorAAA Authentication Failure for UserName:guest  User Type: WLAN USER I saw this error on WLC logs need to confirm if this error is due tosettings in WLC?settings in Radius?...