Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Insider User Research program

Labels

Forum Posts

Hello,I had a problem with WCS report.Getting Cliente Associates to Wireless system (all controllers, all SSID´s), In the column IP address, I saw some IP´s out of my DHCP scope, however when I opened client details, the client IP address is correct ...

I have three Wireless LAN Controllers that are configured in the same Mobility Group. Two of the controllers have a the same WLAN (SSID) but the third doesn't. All three have other WLANs (SSIDs) that have the third controller as the anchor point for ...

Hello,I have a request for a wireless bride connection next to the Harbor.One AP on the top of a roof and two AP´s on moving waggons on a dock.I thought about a mesh connection with ethernet bridging.The question is:Will the radar on the ships interf...

Hi there,I have APs confiugred as FlexConnect and each AP as a primary and secondary controller. I currently configured the APs on the primary controller. My question is whether I need to config the APs on the secondary controller with AP group, Flex...

zli by Level 1
  • 710 Views
  • 7 replies
  • 0 Helpful votes

Just doing some reading and had some questions that came up, if anyone could answer - I'd appreciate it.1.  I do understand that once an LWAP joins a WLC, it remembers that WLC IP and always tries to connect to it - even after you clear the AP or the...

Hello,I'm deploying a virtual WLC environment with just one 1140 for test purposes.I'm trying to create a guest wlan but when I try to create the ingress interface it gives me a generic error.I guess that this error occurs because I just have one phy...

                  All, have anyone encounter this before??XXXXX01#sh arp | inclu acf2.c585.71b5Internet  10.80.1.17              0   acf2.c585.71b5  ARPA   GigabitEthernet0/1Internet  10.80.1.24              1   acf2.c585.71b5  ARPA   GigabitEthernet...

I have inherited a site where the builders have installed a 2504 controller with 8 access points.Unfortunately they have not created an ap-manager interface when they did the set up.Is there any way I can do this via GUI or command line without going...

mbluemel by Level 1
  • 917 Views
  • 7 replies
  • 0 Helpful votes

           Hi ,           I'm planning to upgrade our WLC 2504 from 7.2.111.3  to 7.4.100.0           but the cisco site says           "WLC Version 7.4.100.0 will need Prime Infrastructure Version 1.3 to be managed, Version 1.3 is not yet available ...

The documentation states the Flex 7500 WLAN controllers support the 10Gig transcever "SFP-10G-SR" but mentions no others. Is it possible to install a 1Gig transceiver such as GLC-T or GLC-SX-MM or other types of 10Gig transceivers.                  

sslittle by Level 1
  • 674 Views
  • 2 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card