Wireless

I have a site with Lightweight 1131 access points, with 5508 WLC's in HA running Code 7.4.110.  In 2 areas of one site the access points are bouncing, I have attached the logs from one of the AP's at the site. The switch that the AP's are connected t...

I have 5 Cisco CAP3502E AP's running in autonomous mode. I am thinking about switching to Lightweight and using a controller. Any suggestions on which controller would work best. The reason I am considering switching from autonomous to lightweight is...

Hello ExpertsWLC 5508 and AP in the same location is working great, what config steps are needed to register AP located in remote office with WLC in HQThe Subnet range in remote office is different but WLC reachability is there.appreicate feedbackche...

Since upgrading from 7.3 to 7.5.102.0 we are seeing the following issues and wondering if anyone else is experiencing the same.Wireless clients will show connected and associated to the WLC and have an IP address but are unable to ping out or connect...

We are using 5508 WLC with 3602 APs.Looks like in RADIUS Authentication Called-Station-Id is the MAC address of the AP,but in RADIUS Accounting Called-Station-Id is the MAC address of the WLC.How can we change that behaviour so that Called-Station-Id...

Hi all. I have a very simple configuration that I'd like to do, which I have done before, but yet can't do now.  I have an 891W router, the embedded ap801 instad.  IOS on both is 15.2.  I have an SSID set up, using wpa-psk.  I have a fully working co...

hello,I want to configure a wireless lan controller 2500 which reside on a different subnet than some Access points. Is it possible?

HelloI am receiving on my WLC alarm form IDS about "authentication flood attack""IDS Signature attack detected. Signature Type: Standard, Name: Auth  flood, Description: Authentication Request flood, Track: per-signature,  Detecting AP Name: AP-xxx, ...

We went through an upgrade from 7.4.100.0 for all of our WLC's this morning.  One of the interesting features, that we wanted to take advantage of, was the BYOD profiling that the release notes talk about.  I'm going through the controllers and see t...

HiI am facing the following issue with my 2504 after doing my 7.5 Code upgrade .. Not sure what triggered it. ANyone knows the solution?

Dear allPlease detail guide me change IP address of WLC and AP using telnet? What is fist change WLC or AP ?Thanks

Hi every one please tell me about 2600 series APs can be registered on 4404 WLC. ihave read that 2600 AP required a minimum 7.2.110.0 software. Does WLC 4404 can suport this IOS or any other to register 2600 AP with wlc 4404.