Wireless

I have had a (small) wireless network running in my house for several years but increasingly have the problem that one desktop which connects via a Linksys WUSB54G v4 wireless adapter will connect (associate) with the router but have no internet acce...

Folks,            I am new to mse. I can see everything on the heat map ( ap's, clients,etc) but i can not see any rouge APs on the heat map. Do I have to do anything in MSE for them to show up. I have checked the grid and selected rouge access point...

Is it possible to change 1130AP's hostname, not via CLI or web interface of aironet 1130AP, but via the controller's web interface ?Are there possibility to give any bad impact on the Aironet if I do this ?best regards

HiAny one experienced a white light on the status led, its the "ring light" infront of the AP. ive checked on http://www.cisco.com/en/US/docs/wireless/access_point/1130/installation/guide/113h_c4.html where all colours are listed and none point done ...

Folks,          I have mgmt over wireless disabled on my controller but still able to GUI and telnet into from a client connected to one of the APs registered with the controller.I am running 7.0 code. The output of "show network summry" clearly show...

Hi,I am on a corporate VPN using Itap from my Ipad to remote into my laptop (windows xp) whihc has IP communicator cisco softphone installed.  I am wondering how I can achieve two way sound to and from my laptop through the RDP connection on my ipad....

Good evening, my wrt300n died, and my brother gave me his old wrt54g2. I have done the installation without problem,the only prog is that it was done in French, i do know some, but I would prefer to have it back in ENGLISH.How, can I change the langu...

Hi all :I am testing a Aironet1040 in AP setting. During the process of trial run of GUI on this 1040, I saw a local radius setting and it can set something like FAST-EAP.Is it after using this setting (plus other steps), I can set this Aironet1040 a...

Folks,            I am trying to write a policy that involves 3 things1) Ip address of the controller2) Identity method3) Authentication typeCan someone guide me in the right direction on how about doing such a policy in ACS 5.2.I do not know what fi...

Hey guys, what router could be recommended, I wish to connect my VSAT and 3G together and have the unit do load balancing, I also prefer if it is on 802.11n ... is there such a unit availableSent from Cisco Technical Support iPad App

I have 2 - 1410 bridges ( point to point) between two buildings approx 600' apart.   They seem to be aligned well ( Signal -52dBm, SNR 41 ) and have been very reliable. However, I cannot seem to run more than 26Mbps thru them.Can the distance command...

Hi,As mentioned in the LAN section of this forum I am moving away from a completely flat L2 network to a segmented network using VLAN's in multiple buildings.So for my implementation I envisage per building:Printer VLANServer VLANAdministration VLAN ...

We have a couple SSID's that we don't broadcast.  Currently our desktop group is taking new Ipads out of the box, and they can see one of the non-broadcast networks.I've asked a couple of local wireless engineers, and they said they've noticed this a...