Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

     Hi ,I need to download a login banner page on our WLC 5508 version 7.4.100.60  but i am getting error and the logs is showing the following :*TransferTask: Sep 11 11:05:04.248: #CLIWEB-3-BUFFER_TOO_LONG: cli_web_api.c:3240 Buffer for Login Banne...

We've been using single stand-alone Aironet AP's at our small branch offices with great reliability and success over the last 3 years.  However, we recently acquired an office with only a few clients (10), but it is an old warehouse so it has a lot o...

hometownfc by Community Member
  • 1364 Views
  • 5 replies
  • 0 Helpful votes

I'm having a problem that I am sure is just a quick fix changing something in the configuration of my 5508.  I am unable to ping a device on my wireless VLAN from a device on the same wireless VLAN.  I am able to ping, and be ping from devices on oth...

mlicardo7 by Community Member
  • 1746 Views
  • 10 replies
  • 0 Helpful votes

             1. I've been having a discussion with my peer about client power requirements. We know the grayling a high gain antenna is used popularly in stadiums has 13dbi gain on 2.4ghz and 7dbi on 5. EIRP= Tx + 13dbi  - Loss(insignificant here), a...

Hello! We have Cisco 2500 Series controller and 25 AP's. Recently I faced with task of disabling 2.4GHz radio interface only on one specific AP. I found two ways to achive it:1.     from controller by running command - (Cisco Controller) config>802.1...

iventus82 by Community Member
  • 6105 Views
  • 6 replies
  • 0 Helpful votes

Hello,I want to start broadcasting not only at a 2.4 ghz but also to 5.0 ghz. I have several access points from Cisco (The 1130AG), we already broadcast 2 SSIDS however we would like to increase it to atleast 3. With one at 5.0GHZ.Since we have a cap...

Ins0mnia365 by Community Member
  • 1496 Views
  • 5 replies
  • 0 Helpful votes

Is there any reason why we'd need to use a controller to provide guest wireless from a 1602?  We currently have 1142 and had 1130's before and neither required a controller for guest access.  I've setup a few other model Cisco wireless access points ...

Hi allWe are looking at a new wireless controller for one of our sites, we currently use Aruba in one of them, and we use mac address authentication so they dont get prompted, it jsut automatically connects which is great! however I see that the Cisc...

Hi Folks,This is a bit of an odd one that got me scratching my head, so hopefully the collective can help!We have a wireless deployment that spans multiple sites, the WLC's are located in Central Data Centres and we provide two SSIDs, one for our cor...

Hi all,I wan to use cisco 600 AP without wireless controller, just as a simple router or relay to get dhcp from dhcp server. I need help for how to configure it?

Hi All,We are expereincing some strange problems.1. One particular SSID's is appearing very low single strength & rest 2 SSID's are having good single strength from out of 3 SSID's advertised in one LAP.2. Another issue is one of the particular SSID ...

Review Cisco Networking for a $25 gift card