Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

Hello All,I setting up an outdoor wireless network and need some help please.Will be using 1552h access points.For VoWifi coverage are we limited to one hop back to the RAP?With a clear line of site what is the distance between each ap for backhaulin...

atefbmejri by • Community Member
  • 904 Views
  • 2 replies
  • 0 Helpful votes

We are doing a study on our public WiFi to identfy client connections based on wireless Vendor.  about 40-50% of the clients wireless Vendors are "unknown".  Is there a way to update the list of Vendor mac-addresses in WCS?RegardsChris Kaufman

Hello, I`ve lost at least 6 hours by now trying to make the WAP200 boost the range of my wireless router WRT54GH.I tried setting the same SSID, channel, security and no security, i gave the AP the MAC of the router with his Site Survey, Wireless Isol...

phonemaniaks by • Community Member
  • 1491 Views
  • 0 replies
  • 0 Helpful votes

Getting this message when trying to open a map.  Happens on most of the maps but not all.There was an error while parsing and rendering the content. (Could not load class 'xwt.widetE.layout.Dialog'. Did you spell the name correctly and use a full pat...

I already installed several VoWiFi projects but all of them had the same problem: the wireless phone (7920 or 7921) decides to roam when it reaches the rssi +/- -75dBm (sometimes -80dBm), when there is a better option like -60dBm earlier, which cause...

nuno.reis by • Community Member
  • 5204 Views
  • 9 replies
  • 0 Helpful votes

I tried installing chained certificate in for the https access in wlc 5508. It failed and later i came to know it will only accept unchained cert for management access. But now the problem is i could not get GUI access. It shows error like "This serv...

Hello,I have a little experience with cisco routers but none with the air AP1242AG.The project i am working now is about giving wifi to a village. There is one ADSL router, one switch (2690) and several AP1242AG.Is it possible to have the following t...

I am havingissue with flexconnect mode AP. They are losing vlan mapping very frequently. I need to reconfigure the vlan mapping then only client starts getting IP addresses. Please let me know what may be the issue.AP model: AIR-CAP3602I-N-K9  WLC mo...

vijayanand_n by • Community Member
  • 5408 Views
  • 6 replies
  • 0 Helpful votes

HiLooking for advice ....we have a corporate uk wide wireless ....it has a big subnet and on average 754 active clients at one time . Whet is the recommendation per vlan ? Is it the same as a LAN based network ( 254) .Any advice would be great thanks...

roger jones by • Community Member
  • 854 Views
  • 2 replies
  • 0 Helpful votes

Hi All..I'm having some problems setting up a guest wireless.  First of all let me explain out set up1 x ASA Firewall3 x SF 300-24P 24-Port 10/100 PoE Managed Switch's6 x AP541N-E-K9We have set up the company wireless which worked fine.However i am t...

I'm trying to use customised captive portal for C5760 controller.After uploading the customised page, the captive portal still points back to http://virtual ip/login.html.Have anyone successfully uploaded and managed to used customised captive portal...

raymondfong by • Community Member
  • 5053 Views
  • 6 replies
  • 0 Helpful votes

Hi,I have run config analyzer mostly for audit purpose and i have seen the below result after running an RF analysis (see below).I understood that above 900 the RF index could indicate an issue. Is it relevant ? If my asumption is right, where should...

euanetwork by • Frequent Visitor
  • 1959 Views
  • 3 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card