Wireless

Good Morning,I have a question about Flex Connect.I have read and read and read the configuration guide and I swear I do not see this answer anywhere.We are looking to move our environments to Local Switch\Central Auth since we are going to be fully ...

Hi everyone.I have a small question.I have two 5508 controllers with 6 Access Points (3 on each controller).  The network layout has one AP on one controller, one on the other, 45 degrees and about 100ft apart from each other.In this layout the clien...

Hi allWe have plan to implement Cisco WiFi controller 2504 with APs 1602.In the network there is the ACS server.The goal is to authenticate users, and depend on users credentials AP/WLC will deploy appropriate VLAN.For example Guest user will be push...

I am having a rather troubling issue.  I had an access point that was connected to my virtual wireless lan controller.  It worked fine in the testing environment, but then I tried to roll the environment over to production.  This meant connecting the...

After our upgrade from 7.4.100.0 to 7.5.102.0, we've had intermittent issues with clients connecting.  We have two SSID's.  One is an internal SSID designed for our employees.  Our employees connect to this SSID using their AD credentials, via an ACS...

I've got a project where I need to set up some old, spare 1231 APs at one of our locations. We need to have some coverage right outside one area of the building. What's a good antenna to use for this? We'd probably have the AP inside and just mount t...

I need to setup a lab for testing / demo 2 7926 phones to call each other. Do you have a simple sample CME config to accomplish this (ie, ephone command, realtive show commands to prove it connected or not)?Can I plug my AP directly into the ethernet...

We had a problem with Virtual Machine which Cisco Virtual WLC installed. Virtual Machine files were damaged and the system was not start normally. We have had to reinstall the WLC, but after installation impossible to import current license to new on...

Hello guys,I have a question, when AP cannot find wlc, and error appear like:CAPWAP-3-ERRORLOG: Not sending discovery request AP does not have an Ipit ist right that this error appears%LINK-3-UPDOWN: Interface Dot11Radio0, changed state to up*Mar  1 ...

Can anyone point me  in the right direction regarding error messages (links). Are these error codes made public or just for TAC use?Thanks.

Hi,It is my understanding that when I enable Cisco Clean-Air on my 2602 AP's that currently host my SSID's it will still scan all channels. I spoke to a colleague who tells me that it will not scan all channels and instead will only scan the active c...

I have a 1142 running W7 Autonomous software.  WPA2 Pre-Shared key.Everything is working - clients connect at 300MB M15  however performance is poor, around 110MB/secA show proc cpu shows 100% CPU due to interrupt (not a process)Anyone seen this befo...