Wireless

Hi All,I have to upgrade a couple of 4400s to support 1142 APs.The controllers currently support 1131s, and are on version 4.0.179.11.  (I know, way back there...)Seeing this huge gap between the level we're on and the most current version, thought I...

I have just completed an 18AP install at my place of employment and we have run into a slight problem.The Apple clients on our wireless LAN cannot discover printers through the bonjour protocol.Am I correct in saying this would be related to either a...

HelloFollowing this document: https://supportforums.cisco.com/docs/DOC-18199I am unable to enable IPv6 support on a wlan  as I keep getting this error message:"Cannot enable IPv6-bridging when DHCP Address Assignment is enabled for WLAN"However, to t...

I am trying to configure Guest Access. I have a 5508 wlc inside the LAN (wlc01) and a dedicated 5508 guest access wlc (wlc02) behind the firewall in the dmz. My Mobility group status is showing as control path down data down. I have therefore perform...

I am trying to connect Cisco Aironet 1141 Access point to Cisco 4507 PoE switch. The AP is not working with PoEbut it works if I connect it with a power cord. How do I enable the AP for PoE

hi all,           we are facing a problem with our wifi network in our company, we residency for students nearly 338 rooms per room 2 students so its nearly 700 students staying in our residency and we have 16 perfectly place Access points in our pre...

I have just installed and configured Prime NCS for a customer of mine. One of the advantages of NCS is the ability to monitor/manage switches as well as wireless devices. We tried to add a 3750 and a 4510 switch into NCS and received the message that...

Is there any way to add a non-contiguous subnet to a WLAN on the WLC 4400 software 7.0.98.218 because I have run out of IP address space on a single class C?

Has anyone tried using a 3500 CleanAir AP as a site survey tool? Could you set it up in multiple locations temporarily and gather interference data and analize through WCS? This would use the 3500 AP like you would the Spectrum Expert product.

Hi,I have implemented a Guest WLAN solution as per the recommended design from Cisco. We have two internal WiSM2 controllers providing services for Internal secure SSIDs. Both these controllers are members of a Mobility and RF management group.Two 55...

I coonfigured a 48 port Cisco 3560 PoE switch. I need to connect Access points to it. I connected them to the ports without any configuration.interface GigabitEthernet0/41!interface GigabitEthernet0/42!interface GigabitEthernet0/43!interface GigabitE...

Hello!  I'm looking into purchasing a WAP4410N (possibly two) for deployment in the office.  I have two main questions/concerns I would like to know if anyone can help me shed some light on.First, I see there are two variants available, the WAP4410N,...