Wireless

Are there any training classes for the Wireless LAN Controllers, or using NCS, or using Prime Infrastructure?I've seen a few books for WLC but NOTHING for NCS or Prime Infrstructure. I'm so frustrated with NCS and PI that I'm ready to scrap trying to...

Hi;When i try to get voice related reports or voice audits in NCS, i see an error like "Check that VoWLAN SSID exists". We have a SSID that is only for voice. So how can i mark an SSID as a VoWLAN? Is there any way to configure it on controller or sh...

HI all I have two issue with this configuration : First :I tray to login to my SSID thru the Laptop ( you can find the Password  in the configuration) but the laptop cannot recognize the Password or  (encryption) Second : after making the Switch port...

How do i get the 12.4 code to assign a dhcp address to my ethernet interface from my server? I deleted the default config on the 1141 and searching has not turned up anything useful.

I am having a problem with the autonomous to lwapp upgrade. i am trying to run the following command:arch down /over /create-space tftp://XXXXXX/YYYYY/c1140-rcvk9w8-tar.152-2JA.tar   where XXX is the IP of my TFTP server (laptop) and YYY is the path ...

We have a tech researching some issues we have and he thinks it is because too much traffic on channels 1,6 and 11 which our wlc currently uses.  However, about 20 other neighbors use the same channels with their wireless.   We are a retirement cente...

Hi!Yesterday i lost connection to all AP. It seems like the wlc can reach them, but not configure them. I can see the AP:s in Statistics -> AP join. They get correct IP adresses but i cannot connect to any of them. I am no familiar with WLC so what s...

I just installed this WAP, updated the firmware. Windows computers can connect. iPads and iPhones can't connect. All iOS devices are runnign 6.01. The iPad can see the nework and it says it joins, but it can't browse the Internet. The iPhone does not...

Dears,     we have upgrade the WCS and MSE to new IOS 7.0.230 after that when we generate the network utilization report of multiple controllers its not giving the correct data, the values are in 0.0X format as below. Please help and let me know if a...

We just received a new WISM2.  Is there any way to determine what version it is out of the box (without puting it into a 6509 chassis)?

How long will a LAP configured for HREAP/Flexconnect mode stay in HREAP/Flexconnect mode.  And is this adjustable through CLI?

            Hi AllIm in the middle of looking at Anyconnect for IPAD and Win 7 machines, my users dont want to have to enter a username password on the IPAD so im thinking identity certs. If a use my in house CA and ASA SCEP proxy, i would need to ge...

I have been racking my brain for a while and cannot figure out why I am not getting 144Mbps out of my Aironet 1040. I was reading a previous thread (https://supportforums.cisco.com/thread/2141961) and set it up exactly like it said. I have set the en...