Wireless

We are installing a set of 5508 controllers at one site in Tennessee.At another divisional site we have another controller that covers that division.Both sites utilize the same DNS structure and would like to use the DNS entry CISCO-CAPWAP-CONTROLLER...

                   HI,I am trying to configure a Autonomous Cisco AP as repeater but the configuration is not working.parent and repeater config is attached.On Repeater radio interface goes into reset mode always

Hello,Thanks for all of the help provided in previous threads. I am trying now to deploy the setup that works on some APs and doesn't work on others.For example, on an AIR-AP1231G-A-K9, the following setup works:                   ! version 12.3 no s...

A question came up  regarding wireless controller WiSM1 that  may stop us from upgrading code from 4.2 to 7.0.235.3. The existing deployment of Cisco 7925 phones are on firmware version 1.3.3 and  we were going to upgrade our WiSM code from 4.2 to 7....

We had a WLC 4402 with 25 Licenses. We have about 28 APsThere was another 4402 with 12 Licenses. I put it in the same mobility group and in the same VLAN as the previous WLC and turned it on. Strangely, all the APs de-registered from the original WLC...

Hi all,Can someone help me?I've a problem. Is it problem with iPads or LAP1141n?WLC 4404 and many 1142 and 1141, so other devices laptops, iphones, androind phone works as well.But iPad authorized, but can't get an ip address from dhcp server (dhcp n...

On Cisco WLC SSID layer 3 configuration you can setup a web policy pass through to redirect a connected clients web browser to a certain starting page. Is this possible with a standalone Cisco AP not connected to a WLC?Thanks.

We currently have a Guest wireless setup at my company, instead of using a anchor controller we have dual contorllers with each having one interface connecting out into our dmz and then going out.  it's a pure L2 connection and exits out to the inter...

Hello tech-freaks!Here is my task which does not seem so easy to accomplish:My company is handing out Guest-WLAN access to our visitors. Every visitor has its individual username and password combination. Right now our LobbyAdmins use the NCS GUI to ...

Hi,Interference is suspected in a part of our site. We have clean air enabled on wlc, do we need to enable it on WCS also?Other tools like inssider are supposed to be used for tracing the interference. How do we decide from the outputs that there is ...

Hi Guys,Is any one can help me to configure basic Point-toPoint wireless bridge. I need to connect two simple LAN with Cisco Aironet1310 AP. I required basic configuration with basic authentication between these two devices which is on IOS "123-8.JEA...