Wireless

I am currently working on a project in which I am running a layer three network out to the access layer. I have previously configured a Wireless Lan Controller built into a ISR using VLAN's and subinterfaces but in my new configuration without point-...

Hi Guys,I have a setup like this:A central WLC 5508 running code 7.2 with management vlan 10 ( range 10.10.10.0/24), corp-user vlan 100 (10.11.10.0/24) with WPA2 key, guest vlan 200 (192.168.0.0/24,  on local dsl modem) with WPA2 key...A remote WLC 5...

The AIR-LMC wireless card in my AIR-AP350 SERIES (AIR-AP352E2R) router is on the blink so I want to replace it.  I see that the AIR-LMC350 Series wireless card is used in various Cisco products including PCI adaptors, are these all the same cards or ...

I have an issue with my primary WLC AIR-WLC4402-50-K9 running version 7.0.220.After a reboot of the WLC only one AP can join, all others are rejected. After waiting a few hours (about 3) all APs can join the WLC.What I have done is a software upgrade...

HI EverybodyI will upgrade my Wireless Controller Firmware 7.2.103.0But I dont know WCS will support manager new controller firmware 7.2.103.0 ?is need NCS to manager? or WCS can be manager new controller firmware 7.2.103.0 all feature? Now My hw isC...

Folks,              I have fixing a very bad design where the coverage is not good. The users are complaining that when they roam their phones get disconnected as the APs are connected to controllers in different subnets and cckm does not work well i...

Hello, I am running 5508 wireless controllers. I pass along another agency's WLAN across my wireless network that is anchored to their older 4402 controller.I wish to run the new 3600 series APs and am planning on migrating to NCS and the new 7.2 cod...

Hope someone can point me in the right direction -Basically have a Win08 R2 DHCP server, and a 1941w router.I've got the internet, got the lan clients getting DHCP ok (with ip helper-address set on the 0/0 internal interface).Also have the SSID, and ...

We have a building near a power sub-station, so getting cable run is a problem.  We do have an existing 1252 LWAP close by, but since the building in question is metal, the signal is not strong enough to use.  I would like to put up an autonomous 125...

We use NOMADIX for only banner implementaion. So client gets  authenticated by WLC and has to click OK on the banner. Could have used  WLC for this but sometimes we need to exclude few devices that are not  capable of clicking OK on banner. Would be ...

Dear all I start learning about Mobile IP( read the RFC 3344) and some related RFC documents. Now i have a concern question, Hope that you  clear a canal of obstruction because it makes me getting mad.As i know about Mobile IP like this:+The Foreign ...

Hi everybody,we have a lot of WLANs and AP groups on two WiSM2. Each AP belongs to some non-default AP group. Now I would like to change default WLAN to interface mapping. But change of WLAN to interface mapping on the WLAN configuration page changes...