Wireless

Hello all,I am confused about the cisco docs:What is the minimum WLC/WCS version to support WISM2 controllers ?The datasheet of WISM2 says "minimum 7.0.116.0"http://www.cisco.com/en/US/partner/prod/collateral/wireless/ps6302/ps9798/ps11634/data_sheet...

Hi,My As are not joining the WLC 5508. I am getting the following error on my WLC :*Feb 24 21:31:00.144:  status of voice_diag_test from WLC is false*Feb 24 21:31:10.000: %CAPWAP-5-DTLSREQSEND: DTLS connection request sent peer_ip: 10.79.112.15 (WLC ...

I Have a Cisco ASA configured to filter the wireless guest client subnet using websense. The guest wireless lan controller is in a dmz on this firewall. the websense server is on the inside. I have a wism on the inside with the controller in the dmz ...

Hi, I have three AP but one one is connected with a network cable and the other work on a repeater mode. I need to create two vlans which will broadcast two ssid one for office and one for guest. I know you can't create multiple vlan on a repeater bu...

Hello good day to all, how to configure cisco aironet 1040 series using web configuration attaching through patch cord without using the console.if possible please send me step by step instruction, any help is gladly appreciated.thank you in advance,...

Hi,Just have a minor confusion today, what is the major difference when we have APs connected to the Access port of the Switch of when we have Trunk port connected to AP. Well, I understand the difference between Access port and trunk but on trunk we...

Hi ,Can we use AIR-AP1142N-A-K9  for India Domain ? , as per the compliances it is –N . What is the   technical difference between AIR-AP1142N-A-K9  and AIR-AP1142N-N-K9, both the AP  configuration guides are same will it work or not ? Regards

Hello All, I have 10 Ap´s in a building under a WLC5508 with CleanAir activated, however when the users, turn on a MW oven, the clients located near, lost completely their connections.I have activated the EDRRM, but the interference is in all channel...

Hey guys...I'm new posting here, but I've been reading you for a long time... And I need your help now...I've setup an Aironet 1260 to authenticate users through a Radius Server (IAS 2003). I configured the Remote Policies just to allow the Domain Us...

This original post is edited to correct some factual errors, but the error remains and I still need help with my quaestion at the end!! =======Hello!I have (and my customer) a rather "cute" problem ...  Two months ago I installed a WLC5508 with sw r7...

Hi,I'm having some problems configuring a 2504 wlc and a couple of APs (1131) connected to a HP ProCurve switch. I would appreciate any input as I do not have any experience with HP ProCurve switches.The WLC port1 are connected to HP switch with vlan...

when i reset the device it is open in by default ip in GUI but when i configure the device after that when i enter save and reboot command it is not open with new ip in gui.

I work on a college campus that has thousands of students a day accessing our wireless network.  We have broadcast SSID that the students use to connect to the internet.  The students usually have more than one WiFi enable device on them and their la...