Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Insider User Research program

Labels

Forum Posts

Resolved! Auto RF

We just setup auto RF on all of our 12 controllers. My question is, is the controller group leader the only controllerthat will display the "Last Group Updates" times? or should I see it on all the controllers?

HiI am new to the CISCO forums and could not find info where I searched, so of someone can point me in the right direction it will be much appreciated.We want to roll out Voice over Wireless LAN networks for a company, I need to investigate specific ...

admin_2 by Level 3
  • 1785 Views
  • 5 replies
  • 0 Helpful votes

hi folks: Has anyone of you tried to convert autonomous to lwapp mode? I used upgrade tool v3.4 and it said 1140 is not supported. Or is there any other way to do the conversion? Thanks.regardsAlex

ita_hsieh by Level 1
  • 2992 Views
  • 2 replies
  • 0 Helpful votes

I have 90 1130A/G pure autonomous AP site. I want to deploy a 5508 controller, convert all APs to lightweight, and do it all remotely. I have full access to all the APs and can build the controller in any way to support this. Anyone have any ideas...

craigjost by Level 1
  • 483 Views
  • 2 replies
  • 0 Helpful votes

Hi,hope you are all doing well,I have an LAP 1310 has joined with WLC 4402 and I need to downgrade it to Autonomous to use it as a bridge, I used a command (config ap tftp-downgrade tftp-server-ip-address filename access-point-name) from the console ...

Hi I have a wireless network using AIR-LAP1131G-E-K9 in indoor, AIR-LAP1310G-E-K9 on outddor and a wireless LAN Contrôller 4402 to contrôl all the APs.In order to increase the coverage of the outdoor AP, I have planned to use 802.11b for AIR-LAP131...

I am trying to design Video Surveillance Solutions for foot ball field. Here, we can not pull cable from cameras to MDF the building in Campus Environment. I am trying to incorporate Cisco bridges (Point to Multipoint Environment) in order carry data...

rshah by Level 1
  • 1439 Views
  • 6 replies
  • 0 Helpful votes

I have 90 1130A/G autonomous AP site. I want to deploy a 5508 controller, convert all APs to lightweight, and do it all remotely. I have full access to all the APs and can build the controller in any way to support this. Anyone have any ideas or w...

We have two sets of 1310 bridges that have been setup point to point from our main building to other buildings on the campus. When they were setup originally they were configured with one SSID and a 802.1q configuration for each allowed VLAN. This ...

Hello,I am having disconnections in a WLC4402. The clients are having intermitent connection to APs. I had updated OS from 4.2.176.0 to 4.2.207.0 because of TAC suggestion. The engineer has verified some show comands as well as a debug client. But it...

Hi,I'm having a problem converting this AP to LWAP. I've used the WCS and the standalone tool. Both report successful upgrades. However, upon reload, the AP enters a reboot loop. From there, I'm only able to reload an autonomous image and try ag...

gcdudley by Level 1
  • 2176 Views
  • 10 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card