Wireless

How I solve  a problem in this case ? and Log detaill as below*Oct 13 14:05:56.936: %DOT1X-3-WPA_SEND_STATE_ERR: 1x_kxsm.c:1249 Unable to send EAPOL-key msg - invalid WPA state (0) - client 64:b9:e8:8a:2c:8aThanks in advance

Hi allIm having an issue with just one of my laptops, we have a 4404 controller, that authenticates users via 802.1x using active directory. al my other clients work fine, however I have one that authenticates but it gets no IP address, it says limte...

I have an existing pair of bridges operating at Layer 2 and would like to add a second pair of bridges for redundancy/bandwidth.  I'm finding mixed documentation as to whether a pair of bridges operating as a layer 2 Etherchannel is a CIsco supported...

We have numerous clients losing their IP address and defaulting to a 169.x.x.x address. On the WCS, we are seeing tons of errors Client '(MAC address) (0.0.0.0)' has failed authenticating with interface '802.11b/g/n' of AP '(AP Name)'. The reason cod...

i have two cisco wlc and cisco ap 1130when the client connect to ssid , he shown the speed rate 54 Mbps and become 48 mbps or 20mbps and 10 and become 54mbpsthe speed not stable .how can solve this problem .

I have the latest AirMagnet Planner and don’t see the Cisco 3502i APs listed. Wondering AirMagnet what antenna should I use?

Hi Chaps,I'm 90% sure this is not possible but i'll ask the question anyway.I have a customer that presently has a solution consisting of 2 corporate/foreign WLCs and dual guest anchors. What they wanted to do was offer guest services to new sites th...

Hi;I am having the 4402 wireless lan controller running with 7.0.116.0 code and LAP 1250 and WGB 1250. I configured the WGB AP with the mobility fine tuning commands. But sometimes the WGB and its clients cannot be pingable. If we trying with console...

Is there any way to validate the lobby users that they have a unique session in one computer, I mean that the same username can't login in multiple computers?

How can I configure the wireless not to be shown for users,but  used by tham? On a  Cisco 1242AGI mean when someone do a wireless discovery not see my wireless name, but typing the name be able to connect it.

Does anybody know how to get the WEP key index from a router using HNAP? What method to call and what is the schema?

My setup is in the lab. I'm testing this to move out to multiple remote locations.I'm running 7.98.209 code on the WiSM.I have configured a single 1142 on a state office location mockup wan cuircuit.  The AP is sitting on a trunk port. vlan 1 is nati...

Hi there,I had my 1250 set up to use Radius auth and act as a dhcp server to it's wireless clients. I now have a wireless camera that I wanted to add to the mix but it does not support Radius (EAP) so I've got it configured for WPA2-PSK. When trying ...

I have a problem with my wireless I can not interface dot11 vlan 2 has put this another ip address 20.20.20.1 if I had a client connects to the ssid vlan 2 in this state do not allow ip address gekentand does not work with a static ip address?to tran...