Wireless

I've been using Airmagnet Spectrum Analyzer, it's been giving me some issues. Been looking at Cisco Spectrum Expert and Airmagnet Spectrum Analyzer XT. Just like to know some folks opinions on one or the other. If one may be a little better or have a...

Hi,Does anyone know what I need to mesh the Cisco Aironet 1131 series access points together.  I have a few spread around a small campus and was wondering if this series is even able to be meshed & what components I'd need to make this happen?Thanks,...

Hi, we have an open (Layer 2 security=none) wlan used by vistors to our building. We sometimes get complaints about the wifi disconnecting. I notice on the Advanced tab that the session timeout is enabled and set for 1800 seconds. Is the session time...

Can I load and operate 2 different levels of WLC code on a WiSM (1 for each controoler)?  I need to support 1010 and 1142N so I need two levels of core.

How can i best setup the following:Switch: 2960-24PC-SAP: AIR-AP1141NI have no Wireless Lan Controller.I want to setup 2 Vlan's on the 2960, 1vlan for wired pc's, and 1 vlan for the AP's. I will do dhcp on both vlans.I want to know how the best metho...

Hi!I try to install a 1242 as a repeater from a Dlink DWL-3200AP. When I mark it as a repeater, 802.11g falls down (see image).If I finally get set as repeater, do yoy have to share the channel and SSID? Or Cisco and Dlink are incompatible? Regards.

Ok so I am trying to get my Iphones "onto" my WI-FI access through my Cisco E1000 and have gone to the "start" and clicked on the Cisco Connect, yet everyttime I try it tells me "can not access your router - You can only access your router settings w...

Hi,1. We know that the memory capacities of the AP 1200 are 16 Mbytes RAM and 8 Mbytes FLASH respectively.2. http://www.cisco.com/en/US/products/hw/wireless/ps430/products_tech_note09186a008019fea0.shtmlIn the above link they mention that 4MB is requ...

after some months there has been an increase (a lot) of other WLAN with the same channel as my APs SSIDs, thus this reduce the signal of my APs. is there a way to block these signal or strenthen my own APs signal? i was thinking of something like blo...

Hi Guys,I have recently had issues with clients disconnecting (made obvious by Outlook refusing to connect back up to Exchange after creating over 32 sessions) and also N clients not being able to connect at over 54Mbps or just not being able to achi...

I'm upgrading my 4402 controllers from 4.2.112.0 to 4.2.209.0 and I also need the 4.2.205.0 ER.aes file. On a previous discussion I was given a link for the 4.2.205.0 ER.aes boot file for the 4404 controller. When I went to the 4402 controller softwa...