Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Labels

Forum Posts

Greetings. I need to setup a wireless bridge between two buildings that are around 300ft apart. This is my first time doing something like this and I would appreciate input from anyone that has experience. I've looked through cisco's docs and read a ...

I have aironet 1250 and I want to generate a-msdu packets, but I failed.I used all combinations of following commands and iperf tool for generating packets.(1) a-mpdu enable: conf t -> dot11 addba enable -> dot11 addba timeout -> end -> sh run(2) a-m...

jehunrhee by Community Member
  • 1584 Views
  • 0 replies
  • 0 Helpful votes

Hellothat parameters can use to optimize the roaming of a bridge wmic3205?. The current configuration is the following one, but the roamin he/she doesn't take place satisfactorily.interface Dot11Radio0 no ip address no ip route-cache no snmp trap lin...

jpzarate by Community Member
  • 1426 Views
  • 4 replies
  • 0 Helpful votes

Hi,As i knew when SGSN address or QoS is changed, GGSN send an accounting interim-update message to AAA server, anyway, i'm not confident other parameters (such as RAT) beside SGSN and QoS affects GGSN to send interim-update. anyone have an idea?Than...

Rojer-bkk by Level 5
  • 708 Views
  • 0 replies
  • 0 Helpful votes

DearI have detected several rogue APs in my company, one is with no security key. We are using 4402 WLC, i tried to contain those rogue APs , after this it shows these APs as contained, but no effect on SSID, still anyone can use it. Can someone tell...

adilhayat by Level 1
  • 10471 Views
  • 16 replies
  • 0 Helpful votes

We are starting to roll out a few Win7 devices. Even on our Guest WLAN, they are taking longer to authenticate on the AP1231 than WinXP. The APs are controlled by a WLC, which connects to NAC. Had anyone had this issue? What was your fix?Thanks Mucho...

sjoyce by Level 1
  • 1167 Views
  • 3 replies
  • 0 Helpful votes

HelloI am seeing a lot of the following showing up in the WLC trap log:Decrypt errors occurred for client <CLIENT-MAC> using WPA2 key on 802.11b/g interface of AP 00:17:0f:81:ad:90I have done a fair amount of searching about and I cant seem to find a...

Hi everyone,I configured Cisco WAP200 AP with WEP security. Clients connecting without problems to AP, 100% signal, but DHCP address (offered for W2003Server) is not assigned to any device, it receives APIPA address.The only solution that I find is e...

lsantmiquel by Community Member
  • 1116 Views
  • 0 replies
  • 0 Helpful votes

Getting the following error when trying to Authenticate.Check whether the Shared Secrets on the AAA Client and ACS Server, match. Ensure  that the AAA Client and the network device, have no hardware problems or  problems with RADIUS compatibility. Al...

t.andrist by Level 2
  • 3546 Views
  • 1 replies
  • 0 Helpful votes

HelloWhich tool can help in getting historical data for Guest VLAN configured on WLC. i.eHow long the Guest was connected.How many times he was connected.traffic summary for each connection ( transferred / Received  size)Top 5 sites visited by Guestt...

Review Cisco Networking for a $25 gift card