Wireless

My CWCS web page went down. I don't think its a DNS problem. I can do a NSlookup and it works.two events in my event viewer1.)Apache service named reports the following error: Disabled use of AcceptEX() WinSocket 2 API2.)The System failed to register...

I am in the middle of migrating from Autonomous APs to Lightweight just installed 2 X 5508 WLCs and WCS but the clients are preferring to authenticate with the Autonomous APs rather then the new lightweight ones - I am using exact same SSID and secur...

I have a problem to get high on wireless ee ssid, but get no ip address on the host's anyone knows how to fix them

Hi,I was reading about the clean air technology and found that the spectrum data is sent from the ap to the controller for analysis, so what is the bandwidth used for this ap to controller communication (spectrum data)?

hi1) i need info about which access points supports operating   temperatures as low as - 5 C (minus 5) .2)  i guess all access points supports atleast 0 deg celcius operating temperature.3)  for managing 30 access points do i " really " need a wcs . ...

Hi, we recently installed several AP's 1242AG with domain regulatory N.The client has a LAN controller 4402, besides this AP's with domain N the client has other AP's 1232 with domain regulatory A.The controller updated the firmware to AP's,the AP's ...

Can anyone confirm that it is possible to join a converted Autonomous AP to a 2100 Series WLC (namely AIR-WLC2106-K9)?A came across two documents http://www.cisco.com/en/US/docs/wireless/access_point/conversion/lwapp/upgrade/guide/lwapnote.html and h...

I just setup two new wireless N access points. They are in the right vlan and their status is connected. My problem is when I login to my 4404 controller and go under the wirelss tab, I don't see the new AP's. I see the rest of my access points and t...

Has anyone been able to successfully login via WebAuth on a Windows 7 Phone?  The browser follows the redirect properly but then won't load the page.  We are using a Third Party Certificate and it isn't barking about certificate errors.  It just says...

Hi Guys,Is it possible to Mobility Anchor a WLC4124 WLAN to a WLC4402 WLAN?This would be to enable a migration from an existing WLAN on the 4124 to a new WLAN that is anchored to the 4402. The 4402 will eventually be replaced by a higher capacity mod...

Hi FolksHow we start initial Troubleshooting Wireless related  issues,we have WCS/WLC 4400 along with LWAPP?thanksIbrahim

Does Cisco Aironet 1300 Series Outdoor Power injector (LR2) unit can be supplied with optical interface (ST)?

I have a medium size Cisco Wireless environment and have several Computers On Wheels (COW's) that are getting upgraded.  They currently have old Intel 2915 wireless cards with an external antenna on them.  We have upgraded the wireless network to sup...