Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

I am replacing a 2106 with a 2125 WAC. I uploaded the 2106 config and want to down load it to the 2125. Is there some way to break out of the config wizard on the 2125 after I give it an address and login information so I can download the config from...

sysadmin by • Community Member
  • 882 Views
  • 2 replies
  • 0 Helpful votes

Has anyone installed WCS on Windows 2008?   I see the specs say Windows 2003 or Later but I'm wondering if anyone has actually implemented this successfully.   Thanks

sbeauton by • Level 2
  • 1289 Views
  • 3 replies
  • 0 Helpful votes

I've a 1130 AP which doesn't boot it's LWAPP image from flash. So I tried to convert it back (with tftp server and so on) but after the message that it's using the "reset IP" it tries again to start the (corrupt?) image.Is there a way to stop this bo...

Hi,Im new to troublshooting Wireless issues etc and this is a strange issue, Im not overly sure where to start looking for the cause but here's good as any.Ive a JetDirect box (HP ew2500) I can Telnet to only from a wireless PC, wired nope (95% of th...

Cuchullain by • Community Member
  • 1596 Views
  • 3 replies
  • 0 Helpful votes

Hi,The scenario is: two buildings with a distance of 800 meters one from the other.At the moment there are two antenas on each building, with a wireless D-Link router on each site.The communication between the two sites is ok however there are some m...

Hi, how are you?.In order to make ruting I must have a device of L3 or the WLC 5508 can do this?.  I see that static route can be pointed to service port, but not another interface.Thanks a lot.Andres.

andres.lorat by • Frequent Visitor
  • 3658 Views
  • 4 replies
  • 0 Helpful votes

Hallo we are running some WISM with 6.0.199.4I try to create a WLan with Security VPN Pass-Through.We are using Cisco VPN Client. The colleagues who have configured the VPN Client profiles have defined the VPN-Host with its DNS Name. But the WLan Cli...

mueller.t by • Frequent Visitor
  • 1419 Views
  • 1 replies
  • 0 Helpful votes

Hello all; I'm trying to make heads or tails of something regarding lightweight access point support.  This is in regard to the 1100 series of access points; the data sheets for the 1100 say that it can be converted to LWAP, but that it can only be u...

marcs by • Level 1
  • 1823 Views
  • 1 replies
  • 0 Helpful votes

hello,we have several 7921 voip-over-wireless phones and see this problem: the phone uses dscp 24 (CS3) for signalling traffic. nevertheless when this frame arrives at the access-point and is tunneled through capwap the dscp-value of the capwap-packe...

heinz.kern by • Community Member
  • 1517 Views
  • 1 replies
  • 0 Helpful votes

We have two ACS 4402 with software version 5.2.193.0 . What version should I upgrade to ?The ACS is running version 5.2.148.0. What version do you recommend here ?RegardsJohann FVolda Universiy College, Norway

johannf by • Community Member
  • 1044 Views
  • 1 replies
  • 0 Helpful votes

Hi everybody,Currently I'm working on a project for an auditorium which has capacity for up to 2500 people. The auditorium also has Acoustic Design which permits the cancellation of noise (at audible frequencies).The auditorium works for Conferences ...