Wireless

Hi,I have wlc 2106 which is connected to my l3 switch 4503 , I have configured wlc 2106 with one wlan but now i would like to get one more wlan which will have access for only internet to guest users  ...What should i do on WLC 2106 or what commands ...

Hello,I have a problem with roaming between wireless antennas since phones 7921. The phone does the roam between APs when it reaches a -78dB threshold at which the call is cut or degrades much.In our network VoIP over WLAN we have: 802.11b / g; WLC 2...

I have a WCL 5508 at my Host Location and want to install several AP 1142s at a remote site over MPLS. I will have two SSIDs. One for Corporate Users and one for Clients.corporate users will authenticate via Radius Server at the Host. I want to route...

Hi all,I have a network of about 20 Aironet 1200's that i need to make a couple of changes on (for all of them).I need to add a SSID and set that SSID to not be broadcasted.My questions are: 1) Can i add the SSID in without having to bring the AP dow...

Is there a way on WLC or WCS to set up an SSID that would specifically cater to Mobile Devices (IPhone, Droid, IPad)?  Also if one were setup how could I go about policing this to be sure mobile devices only got to that SSID and no other ones?

I have a WAP200 AP configured with 2 SSID's.  The AP is configured to allow the use of repeaters and i have 2 other WAP200's acting as repeaters for each SSID.  The WAP200 repeater i have configured to repeat the signal for the 1st SSID works perfect...

Any there a way to stop advertising Cisco appliances on a WiFi network. For example when I logon to our in-band Guest Wifi using nmap I can see the Cisco Controller interfaces and the NAC server trusted and untrusted interfaces as well as the Web Ser...

Would anyone have a copy of the c1240-k9w7-123.8 JA.tar or commonly known as the default file. They don't have it available for download, and I need it to repair a c1242 access point which mistakenly got a 1200 tar file loaded on it!Karl

is it possible to map more than one vlan on one SSID.  or more than one AP group per Access point (I couldn't find such possiblility while looking at the WLAN controller GUI or cisco tutorial but I'm still curious if there is any way).

Hi,I was using 1100 AP in which it has some IOS problem so on my boss request, i tried to change/upgrade the flash: c1100 file.So, i deleted the flash file and at a sudden it completely went off red, green, red light order its glowing at status. It h...

If I use machine and user certificates does that mean the machine get's an IP address, authenticates, the user then logs on which causes another DHCP renew and user authentication?  Is it better to use machine and user or just machine?