Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, August 17 , 2026 through Tuesday August 31, 2026. Our experts Saikat Nandy and Prashanth Bargur Hanumantharayappa will be waiting to assist you and resol...
Hi All,I have a wlc 4400, and am attempting to have two wireless clients on the same ssid talk to each other. Is this possible?Thanks!chris
3G streammedia servce, I use a temperary cisco2811 router for NAT for the streammedia server to allow the IP to access. In this situation, 3G mobile phone access online music, the buffering time is normal, about a few seconds.Now, I want to remove th...
Hi everybodyis there a way on the wireless controller or the ACS to configure a guest or a failed vlan if the 802.1X authentication was not succesful, like it's possible on the wired infrastructure?Thanks and regards
Hello Netpro!I m Design a Wireless Solution for Hotel,so how can i get start? any link for this matter its much appreciateThanks
Hello everybody,I want to know if the a wlc like 2100 or 4400 series support the lap521 ap.Thanks.
Dear All,I am looking for the software or hardware that can control all the wireless network divices like Cisco, 3Com, Motorola, ...? Does anyone else know about this software or hardware?Thanks,Pisal
I confgiured one WPA key to one of my SSID. Is there any way to view the WPA password from the controller.
Hi Experts!Can I have wpa and wpa2 on the same SSID available for both kind of users?Regards,Miguel
Hi all,I would like to configure MAC filtering on my 851W Router. I mean, only certain MAC address could have access to the wirelless network.Is that possible?How is the best way to do that on this router?Thank youRegards
Customer is looking for a document explaining all Wireless terminology form Ciscoexample:•Lightweight access point—An access point running software that makes the access point work with the controllers•LWAPP—Lightweight Access Point Protocol. An IETF...
What is Cisco best practice for RRM running between four WiSMs (8 * WLC).Campus has 800+ LWAPsPlease advise.
AP is registered to primary WLC. Will clients stay connected to WLAN when the AP failover to secondary WLC.WLAN1 -> WPA2 (TKIP) + PSK.WLAN2 -> WAP2(TKIP) + 802.1xPlease advise.
i need drivers for card AP1231G access poit cisco in my notebookcoloquei o cartao no meu notebook e ele pede drivers que eu nao consigoachar alguem me de uma [email protected]
I have a AP-1231G and would like to have a managment IP on the FastEthernet Interface. Is this possible?I read, that the managment IP has to be on the native vlan. Bridge-group 1 is automaticaly to the native vlan and a second bridge-group hasn't rea...
Hello everyone,I am new at setting up root and non-root bridges. I am trying to set-up three 1230ag devices.One as the root and the othe two as non-root, I copied the config txt from the root andcopied that into the two I am going to use for the non-...
