Wireless

Not sure if this has been asked or covered.We have a 2106 (running 4.2.205.0). I was wondering if there was a way to setup a WLAN that uses Web Authentication, where that would use a RADIUS server to authenticate the user instead of having to manuall...

Looking to log client connections along with IP Address and MAC address. Is there a syslog facility that includes this information or a document that lists the various logs that are sent?

Getting the following:Oct 8 11:00:38 wlc-wism1 wlc-wism1: *Oct 08 15:00:38.763: %APF-3-GET_TKN_BKT_FAILED: apf_policy.c:327 Could not get Token Bucket Entry. All token entries are already in use.Oct 8 11:00:38 wlc-wism1 wlc-wism1: *Oct 08 15:00:38.76...

Dear all,From H.Q to the branch office we need to connect using wireless. distance is 9 km.do you think 1500 series AP will be a good option in this scenario. what type of antenna i need to use and approx gain of antenna.can anyone provide directions...

I have two cisco 1200 that i need to pass traffic from one building to another. I have two 3524 poe switches one on each side. i want to trunk or pass 2 vlans over the radio but i need to set up like a trunk as if i was just trunking the two switches...

I noticed on one of my clients AP's which is an 1130AG series that it had a setting for SNTP. I was a little surprised that it did not have the capability to use regular NTP.The SNTP servers configured for the AP were two Cisco routers.Is this a comm...

After configuring a stand-alone 521AP, I am unable to get to configure mode. I can SSH, login and then get to enable mode. However, "configure" is not one of the available options. My list of available options are attached, as is my sanitised config....

When you have an SSID set to anchor at another controller and you have AAA Overide enabled for Dynamic VLAN assignment on the back end where does the VLAN get assigned. At the mobile controller or the anchor controller?I am looking for a way to Ancho...

I am in the process of upgrading my controllers from 4.2.130.0 to 4.2.207.0 and am moving access points from an old controller to a new one. I have a situation where several of the older access points (1231's, and 1242's) will not move to the new con...

Dear all I knew that 7920 is not supported by cisco to work with 1252 AP. (7920 can't authenticate with the access point although that 7921 is working fine)I red in other conversations that the problem in TKIP encryption , but it doesn't work with WE...

We have an autonomous wireless network that is using WPA/TKIP, and authenticating back to a Windows 2003 IAS Server. We are going to be adding wireless to other offices, and are looking at implementing WDS. I have found documenation on Cisco's site r...

Good morning!Just have a general question, is there a command on a Cisco 1231 AP to display a list of adjacent APs and their SSIDs? Thanks!Difan

Hi,I'm looking at installing a new 802.11g based wifi network. However in the same facility there's a very old (from 1999) 802.11? network running. Don't know much about this old wifi network, but any idea's on whether this old network would cause an...