Wireless

Going from 4.2.112 to 4.2.205 along with boot image. The AP's have Static IP.1. Upgraded backup controller.2. Using WCS template changed the primary and secondary controller for group of AP's. This will move them.3. Repeated above step till all the 1...

HiI've installed 3 new 1252AG access points, each with 3 2.4GHZ and 3 5GHZ Antennas. I am able to connect fine to each Radio on the AP's but not at over 54mb/sIn the Web Interface | Network Interface | Radio Config | Data Rates, I do not see where th...

Can you use your own SSL certificate on an ACS 5 server?I have loaded an SSL certificate from my CA onto my ACS 5 eval server, and have selected it in the ACS admin screen as the cert to use for EAP and HTTPS. However, it is not being used for the we...

I am working with the ACS 5 evaluation VMWare image and wanted to apply the latest patches (5.0.0.21.7). I've tried to apply the patches twice, on two different VMWare instances, to no avail. The "Distrubuted Syustem Management" screen will report fo...

Had Anybody any experience withintegration NAC OOB and 802.1x?I have seen that there are some issues about it.

Is there debug ap "command" or some other command that can give me Access Point Temprature ?I have a AIR-LAP1131AG-A-K9 that reboots every weekend when the AC is turned off and it gets hot.Also while we are at debug ap "command" is there a document t...

Hi!I'd like to differenciate users sharing the same ldap directory and radius authentication.For example, if I have a student and a teacher, i'd like to be sure that the student will stay on its vlans and so on.I can do this by using vlan attributes ...

Hi,I need to know what is the function of the option "External Configuration Option". In all the cases I do not enable this option and I do not have problems. regards,

I am looking for documents about using wifi in highly reflective enviroments: rooms with aluminium floor, walls and ceiling en very little materials that absorb rf. (cleanroom enviroment) Any hints are appreciated.

Hi,We have a customer link for a distance of 10 kms outdoor installation, for the past two days the link is slow, suspect antenna alingment and asked the customer to observe ,attached is the link status can you suggest for better performance.

Folks, Can Location server be installed on anyserver or does it have to be installed on the appliance. I was to demo it to a customer of mine and wanted to see if i could install it on a linux box?Thanks

Hi Netpro,does anyone know about the Cisco Appliance server 1113 can generate the Certificate Signing Request ? how to make this working with Verisign server ?your reply will be highly appreciated.thanks a lot.

Is anyone successfully using Band-select ? I was reading the 6.0.182 release notes and found this comment:"Band Select and Load Balancing CLI CommandsThe config band-select and config wlan band-select CLI commands appear in controller softwarerelease...

I have a Point to Mulitpoint connection. On top of a tower i have an cisco 1410 bridge with an omni antenna. I have 3 other sites that are currently connected to the omni from about 1,2, and 6km away. I am adding 2 more sites that are 8 and 9 km away...

Hello , I have a message error in the WCS (you can see the file attached )Keepalive message are lost. Can you help me for this question. best rtegards