Wireless

We've got a WS-C3750G-24WS-S50 that has been happily running in switch mode for some time. We now need to use it for IP routing as well. However as soon as I add "ip routing" to the config the WLC and the switch start missing keep alives. "sh platfor...

hi guys , it is regarding to the outdoor wireless lan consist of several mesh AP.I have two wlc 4402 , and right now ima trying to test out on the failover issue. It works fine actually but however,on one of the mesh AP i attached a ip camera to the ...

Hi all,i want to know if CISCO Wlan Controller can support third party Access Point (SENAO ENgenious EAP3660).thanks in advance

Does any one know what a viop config on the 2800 router should look like?

Any suggestion on how to configure Radio Resource Management?Thank youVic

I was wondering if anybody has received this type message before ?IDS 'Auth flood' Signature attack detected on AP Cisco2 protocol '802.11b/g' on Controller 192.168.2.12.The Signature description is 'Authentication Request flood', with precedence '5'...

We have WET200 wireless bridges, which we use in vehicles with mobile data terminals, to provide a network connection. They have the most up to date firmware.Occasionally, they lockup and lose the network connection. However, as we have about 100 of ...

Hi Allwe got a some of error message from our ITP(7613). I already checked error message meaning in the cisco website.but they didn't mention anything.my curious is what does mean at the below error message and how do I do next action?*Jun 14 11:51:0...

if an ssid, intended for remote, is configured for local switching, what vlan on the wlc should the interface be configured with?we have the same topology for h-reap in the following document:http://www.cisco.com/en/US/tech/tk722/tk809/technologies_c...

Hi, allI have a problem with DHCP IP distrbution.My wireless environment is WLC2106 + 6 LAPs(1131AG).The symptom is that WLC sometimes distributes duplicated IP addresses to clients, so WLC have wrong ARP tables.Eventually, some clients which have du...

I want to assign a static IPnr to a LAP521. FYI, I'm not using a CE520 switch but an unmanaged 3com switch. Preferable I like to use CCA.

I'm unable to setup the connection between a WLC526 an a AP521 (controlled) access point. I'm not using a cisco switch in between but an 3 year Old 3com switch. Using CCA I can see that the AP has announced itself to the WLC, but the AP is not config...

Hello, I've just bought the lightweight 526 controller for lightweight access points. Along with it, I bought some four-five LAPG521. In every configuration guide I can find, it is _always_ put together with the catalytst 520 poe switch. is this a re...