Welcome to the Cisco Community Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Monday, September 14, 2026 through Monday, September 28, 2026. Our experts Shree Hari AB and Suman Sinha wi...
How do I set up local dhcp scopes with two controllers. I guess I can not create the same scopes on both controllers ? What is best practice ?RegardsJF
When configuring my 4402 controllers I have to create the same interface on both controllers. But what about the interface ip-adress? Can the interface ip-adress be the same on both controllers ?JF
Hello;We have base licence for 100 AP on WCS. In our network we have 75 Cisco Aironet 1242AG series AP.But WCS give a error like "Percent of AP Licenses Used: Violation".When we look at the AP count, we see that there is a two record for each AP. One...
Hi all,I've installed four WLC 5.1.151.0 and the clients have roaming issues. When a client roams i can see it as "Mobility Role: Anchor" on the first WLC it connected and as "Mobility Role: Foreign" on the WLC it roamed to. The problem is after the ...
Hello! I am new to Cisco MESH and I have a basic question. If I have a 1522 operating as a MAP is the FastEthernet port useful to uplink a switch. I have a need to provide wired connectivity on both ends of a wireless MESH. I know that the traditiona...
Anchor WLC redundancy is achieved through the mobility groups. For redundancy, we can increase the mobility group size, including additional controllers for redundancy.Does N+1 redundancy works across different mobility groups (Anchor WLCs in differe...
Dear all,We have WLC 5.2.178.0 and AIR-AP1231. All APs have been converted to light weight image successfully and they have joined the Controller and they are working fine.The problem is that from time to time the access points get de-associated from...
I have Cisco 1230AP's providing access to my LAN for laptop users. The encryption is via WPA. I now need to setup my guests/visitors - keeping them away from my LAN and internal network and they can only (guest) use internet but all employs should us...
Hello,I have a configuration where I need an access point(1131ag) to disable the dot11radio interface or or disable the ssid when the fastethernet0 interface is down. Is there an option for this?Thanks,Dan.
Guys,I have been asked to survey using a Cisco 1242 AP.We only have the LWAPP model can i survey with this and if it needs to be IOS can I role it to IOS any comments gratefully received.Mick
Hi All, Can somebody tell me how this command is used with Cisco Access pointsip http secure-trustpointThanksNikhiL
Is disabling the radios on the antenna enough to replace the existing 3 of the 2.4 Ghz antenna with a different model?Not sure if I need to shutdown the power by unplugging the POE cable from Power Injector and RESET the button to also stop the batte...
We have 9 1010 AP's which all were just plugged in and auto configured themselves from the controller. We now need another AP so I was told that the 1131 was the replacement model. But I cannot for the life of me get it to be seen by the controller.....
Does the Cisco 1121 AG Access Point support WPA2? I cannot find any clear information. I was wondering if maybe the latest IOS supports it?
I'm having a little trouble setting up a WGB on our autonomous system at work. I reviewed a couple of recommended docs but can't seem to get the bridge to associate to the network. The bridge is setup on our ACS server. Could someone review the attac...
