Wireless

Please see attached Visio to understand my topology. I am using a 1242 that is running c1240-k9w7-mx.124-10b.JDA. Issue: When I try to use TCP 80 (HTTP) from the laptop I get "the page cannot be displayed" even though I can ping the server with 30 to...

Hi,I've configured a 7931 phone with one line (and have allowed a maximum of 2 calls with a busy trigger of 1).I'm trying to work out how to toggle between two calls that in the following scenario:Incoming call on line 1.Call is answered and then tra...

Hi all;i have an issue, we have a small wireless network using a cisco 2000 series WLAN controller, and for sometime now it would drop connectivity to the cisco accespoints. it would normally be resolved by resetting, however recently it took a turn ...

I need know how i could increase the nvram memory?. because i have an cisco Access Point with only 32k in nvram and i can't load a file configuration since a WLC , The size of file is more than 32k

Hi,My setup consist of 2 controllers(Cisco 526) and 8APs.Cisco documentation has stated that it supports for 2 controllers per network. But has not shown how to configure it.Please advise on how i can configure the 2nd controller to aid 8APs.How woul...

I just upgraded my wireless LAN card from a PCM-350 to a brand new CB21AG card. I installed all the software that came with the CD (ADU, ACU, drivers) and am now getting an error saying that the ACU can't access the wireless LAN Adapter.When I start ...

Under the 'Rogue Summary' on our WLCs we sometimes see some 'Active Rogue Clients' and 'Adhoc Rogues'. I'm just wondering if this is 'FYI Only', or am I meant to do something with this information? I've tried MAC Filtering and/or adding the offending...

This is what I hope is an easy question: can I do a point-to-point bridge with a wireless lan controller (4402 running 4.2.176.0 if you need specifics) without running a mesh version of the code? Can I do it using 1242 AP's?Thanks in advance....

Hello,I have a lot of alert messages from my APs and I don't understand what it means exactly.Can anyone help me?Here is the message (on DFM - Alerts and Activities):Event_Description OperationallyDown Component PORT-AP-1200-VINC33/7 [Fa0.1] Type L2V...

I am deploying a new LAN Controller and 1142N APs. Even though I have gone through and verified that all the N setting are enabled and what I believe to be correct, I can still only see the G or A networks from a laptop with an N card.

Hello,I have a LAP1252AG-E-K9 managed by a WLC embedded in a Catalyst3750G. My question is the following: how can I disable the 5GHz radio module using the WLC (I desire leave only the 2.4GHz module). In addition : in case I put in the LAP only 3 2.4...

I have a NM WLC with four WLAN SSID and 8 APs, I want to broadcast the four SSID in 7 APs and just one SSID in one AP. Is ther a way to do that?Thanks.

Hi, Every evening, my access points disconnect from the controller. I have to reboot the controller for them to re-associate again. I don't know what iscausing this. Has anyone seen this before? Any advise will be much appreciated.WLC4402 version 5.0...