Wireless

We have an 'old' 350 AP which still has Vx on it. In the past we have used Aironet VxWorks to Cisco IOS Conversion Tool and Image.I cannot seem to download it from the 'download' area any more - it's asking alsorts of registation questions ?Do I have...

Hi there! I have just migrated my wireless network to controller-based. Coverage was not an issue when everything was in autonomous. Now that my access points are lightweight, I'm starting to see problems with regards to coverage. Two of my access po...

Hi, Two questions about Requisites to install WCS..1) Should I install WCS in a Windows 2003 Workgroup or in a Windows 2003 Member Server.2) In the procedure Configuring WCS to run as a Domain User, can I use any user in AD or that user must have adm...

HiMy company bought the above named sensor card. We have now tried on 4 different laptops, but we can't get it to work.We have followed the instructions and installed the software before inserting the sensor card. The software version is 3.3.52. Afte...

I have 2 controllers 2106 both with the same mobility group, I have 3 APs in one controller and 3 APs on the other. I have just one rogue detector. Do I need a rogue detector on both or just in one controller?

Hi I am using a WLC 2112 and LWAPs,I am facing the following problem.1. APs are getting associated with WLC,getting the dynamic IP from the DHCP server,but APs RF is not coming up,When I see the Monitor,it shows the APs but RF both 11a/g and 11b/g sh...

Hello,Currently we have a WLC anchor controller running V4.2.130 . And it has one real Guest wlan which is directed to the Internet . I would like to know if we can configure another Guest-like wlan on the same anchor WLC. The aim is to create a seco...

HelloA colleague has been moving SVI from one switch to another, including the SVI of the mgmt vlan my AP are using.Thw whole process involved creating a new AP mgmt SVI on the 'new' switch and then modifying DHCP settings to give the AP a default ga...

I have some problems with peap authentication. Here debug of my AP:Mar 13 09:50:39 10.15.1.14 2370: *Mar 1 19:24:18.889: dot11_auth_dot1x_start: in the dot11_auth_dot1x_startMar 13 09:50:39 10.15.1.14 2371: *Mar 1 19:24:18.890: dot11_auth_dot1x_send_...

We have a client that has a multi storey office block, They wish to have sepearate SSIDs per floor and a common SSID for the ground restaurant area where all cllients can access without changing their WLAN profile., they are talking about 30 floors.I...

This may be a stupid question, but when setting up a new building/floor is the square footage really important?How do you acquire the square footage information?