Wireless

I just installed the latest signatures and I get the message: SDM is unable to get signature details from router".Any suggestions on how to correct this?

I am getting ready to submit requests for equipment replacement and I am considering replacing our 4402s. I was not able to see any perf comparisons between the wism and the 4404 units. I assume that the wism would be better given that it would be on...

I have 2 1300's in bridge mode. Is there a way to see what the connect rate is real-time? Also, what are "normal" stats on the detailed stats page, e.g. CRC's, packet retry's, etc. Thanks in advance,GL

Hi All,I just need some help in configuring the following.I have 2 LANS separated by about 150feet. I need to connect the 2 LANs together.LAN1 has a 6509 switch with 10.35.80.x network. The ACS servers needed for authentication are in this network. L...

I have an AP1220 that have the radios upgraded and converted for LWAPP. The led status lights atlternate blinking with the middle showing red. Can someone refer me to a document that gives me the interpretation of the different led combinations and w...

Hello and happy New Year,I am trying to generate a PEM file to upload to my Cisco 4402 Wireless LAN Controller. I have an unchained certificate from Verisign and have followed the instructions at http://www.cisco.com/en/US/tech/tk722/tk809/technologi...

tried put sis laptop Dell 610 Lati.on home network with desktop; Road runner using linksys router in between cable modem & Netgear wireless.Both XP;could'nt get help from Brighthouse.Can any1 help?????

I'm trying to figure out if it is possible to feed this accesspoint with the Cisco Pre-standard Inline Power from a 3524-PWR switch.When I turn on the Accesspoint it shows that there is not enough inline power available to turn the radio's on. Accord...

Hello,I have to manage a wlc 4404. According to me he acts strange.Only ports 1,2 and 3 are connected. The ap-manager and the management are linked at port 1. So far so good.If I look at the wireless-tab I see all AP's are connected at port 3 !! All ...

Dear all,I want to configure a 876W router to have a public wireless LAN with internet access only and a wired LAN (different IP network) with an IPsec VPN connected to the companys network.I want to seperate the two networks putting them into two di...

Has anyone had any client compatability issues when mixing 1242 and 1231 AP's within the same site? My older Symbol clients are freezing up etc when roaming to the 1242's while new clients are fine roaming within both flavors of AP's. The configs a...

Dear Sir,Please guide me how I can expand up my Signals ?I am receiving signals from my upstair room I need to be expand these via an antenna or any thing ,Please guide me how I can be.http://cancee.com/vpn/Signals.JPG Regards,Hammad

I have a 4402 WLC to act as an anchor controller in a DMZ enviroment.My wireless clients associate with several WiSM's in the local network.I would like to create a WLAN that uses 802.1x (WPA2) to authenticate the clients and then bind them to the an...