Wireless

So I have a 526 mobility express controller and 3 521 APs. I've got the APs working but not handing out the DHCP info. My tiny little network has the address range of 192.168.0.0-255, 1 being the dhcp server(its a little dlink). I have the management...

Can the 1310ap receive it's power from a POE switch?

Hi there, I'm experiencing some issues with a 1310 LWAPP on a University, here is the scenario:The AP is directed to some specific classrooms and at a certain point the radio goes down or at least there is no more communication between the clients an...

I'm looking into upgrading current Cisco 1232 (G) to an (N) solution. Can I upgrade the 1232 with a radio change only or will the 1232 not accept the change? Will I have to replace the 1232 with a 1252. If anyone has a white paper on this it would be...

I'm implementing a Cisco mesh topology, and I would like to know if there is possible for me to have the mesh topology in one site and the wireless lan controller in a remote location, through the internet.

Hello all,I would like to know what are all possible reasons for wireless clients to get disconnected from LAP (to WLC) solution. We have WAN (MPLS) between LAP and WLC and on the remote site (where we only have LAP, since WLC is in central site) we ...

Hi,my customer want to install WCS-base (to manage 2 controller 4402-50 and 50 AP) using a intel server with strong performance (bi-processor 3,6 GHz, 4 GB Ram) but unfortunatlythey want to use the same server for the applications listed below.I've s...

HiI have upgraded my controller to 4.2.130, and then I attempted to give one of my AP's a static IP address, and since then its in a booting loop.I partially registers with the controller, and then reboots itself, and I cant ping it or reset the conf...

I am trying to get a DD-WRT router to function as a client bridge on a wireless network off of a 871 router. When the DD-WRT device is configured, you can ping the device from ANY other device on the network except for the 871 and the devices behind ...

I have recently upgraded a WLC to version 5.0.148.00 from 4.2.99.0. And since this upgrade I receive an authentication error on the client saying - The wireless network authentication failed because you entered the wrong single sign-on username / pas...

How do you configure the Lobby Ambass. Profiles. This is so I can set the defaults for users that the Lobby Ambass configures.

Can anyone explain exactly what the "virtual dot11 radio0 " interface does or how it is created . We are having an issue with a single AP where it is sending a trap for this going up and down . We have literally dozens of other 1230's around and they...

If I want to user 1200's as point-to-point bridges, can I run them under LWAPP or do they have to remain Autonomus?

I've been using iperf to test a Lenovo w/4965n chipset against a 1252 on 5 Ghz.Iperf shows approx 55 mbit/sec and 300 Mbit is indicated as nominal speed on the adapter. I would expect somewhere around the double of that. It doesnt make a difference w...