Wireless

I'm creating AP groups so i can have an SSID span multiple vlans. In the WLAN/SSID configuration, it's mapped to a specific interface, which of course dumps me (the wireless user) out to the vlan this interface is associated with. Should the SSID be ...

I can log onto my AP using the cisco and password. However, if I try to access network interfaces, I am prompted for a username and password again. Apparently the two are not the same. Is it better to reinitialize the unit and replace the configurati...

I have a few AP1231G models running IOS 12.3(4)JA. What is the current version supported? Can these models support both WEP and WPA configurations concurrently?

Does any one know if the Open SEA supplicant is supported because Cisco isn't part of the Open SEA Alliance.

We have WCS 4.1.83.0 is installed in 2003 Server but nowadays the same is instable, When we done some analysising and found that "Wireless Network Management Application" was stopped and we were not able restart it. There is no problem with OS as wel...

hello experts!!!we're doing wifi hotspots and will use 870 to backhaul the mesh network.is there an option module for the 870 router for 3G? i haven't seen this router and still searching cisco.com. if not, what type of cisco routers similar to 870 s...

I'm trying to set up a wireless bridge between my 1200 series and 1130AG access points using the "A" radio. I'm doing this because I run the "G" radio in AP mode for my wireless clients to access. However, I can't find the commands to set up the 1200...

Any idea what is these errors is about?My wireless A.P is giving me these errors?

I am trying to get a certificate on my WCS so that I can prevent from having to click on the "Continue to this Website" link everytime I log into the WCS.I have created a .PEM file from the WCS but when I send that file to CA, they are saying it is i...

Does anyone know a procedure for resetting the enable password on a AP521 access point ?

I have 1252 autonomous APs acting as non-root bridges and 1242 autonomous aps connecting to the 1252s. I wish to lock down which 1242 access point can associated to which 1252 access point. I don't want the 1242s to roam.Any suggestions on how to con...

Hi everyone,I'm looking into a project to cover a large residential area with wifi using the 1500 series access points on 2.4Ghz and using a 5Ghz backhaul.Before I go ahead an organise a site survey I'm trying to get a rough idea of the coverage dist...

Good afternoon,Anyone have 802.1x standalone ap wireless example with guest vlan and valid vlan? I need the configuration of the wireless and switch port. When user to try associate and accept, valid vlan, not accept guest vlan ( or ssid ) i don't kn...