Wireless

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

review


Labels

Forum Posts

I have a cisco 1400 that that show interface show int dott1 radio interface reset protocol down. I had a surge in the area and had the problem after. I copied the config over to a new Ap and power injector and the problem persists. The bridge is the ...

h.wall by • Level 2
  • 929 Views
  • 0 replies
  • 0 Helpful votes

hi,do cisco offer a really nice graphical survey tool that integrates with WCS ?I need to do an assisted site survey, can i use WCS (thought it was just a monitoring tool,config tool for use on a server/pc) I need to walk around and click to point ou...

meggerman by • Level 3
  • 1147 Views
  • 5 replies
  • 0 Helpful votes

Hi,We are considering to implement 1250 AP with 802.11N standard and use wireless IP phones.I'm not a voice expert but I can't find a cisco phone which supports the 802.11n ( draft ) standard. Is there a phone which supports this and if not when will...

Hi allThanks in advanceI have 5 1200 access point.i want when i add mac address to one access point it shoult be syncronize to other 4 ap also.i mean when i gave access to someone i have to add that mac address to each and every ap. is their any sett...

san_dec21 by • Level 3
  • 665 Views
  • 1 replies
  • 0 Helpful votes

I have 1242 AP whose IP address is configured as static. I need my clients to associate with the AP, and get IP address assigned by AP. But I didn't find any option where I can put the range for the DHCP. Kindly guide meCheers

mansoor9349 by • Community Member
  • 1407 Views
  • 3 replies
  • 0 Helpful votes

I've been searching but I cant find any document that describes how to configure Radius authentication (and accounting?) with guest access. What attributes are needed to set up a time limited guest user etc..Anybody got some manual or step by step in...

s.hellman by • Level 4
  • 489 Views
  • 0 replies
  • 0 Helpful votes

HiI have a need for a 3G connection into the Internet cloud by a "device". This device will then provide wireless connectivity to laptop users. BUT I MUST restrict the laptop users to two specific Internet destinations. Is there a singlr box solution...

netops01 by • Level 5
  • 1079 Views
  • 2 replies
  • 0 Helpful votes

We are doing a site survey for wireless infrastructure. Redundnat controller implementations is what we are looking at. We were informed about using 2 controllers for redundancy but now during site survey, it has been informed that a different versio...

psshergill by • Community Member
  • 1160 Views
  • 3 replies
  • 0 Helpful votes

Good morning.I've got a problem on my 1230 & 1240 APsThe association with clients is running well, but every time after a short period (less than 1 second), the AP deauthenticate the clients, showing me this log : Mar 1 00:14:45.979 Information Inter...

Descotes.D by • Community Member
  • 1467 Views
  • 5 replies
  • 0 Helpful votes
Review Cisco Networking for a $25 gift card