Wireless

Hi,I am working on setting up a WLAN for guests to use for Internet access. I set up a WLAN and used a VLAN to seperate it from my prod network. I set up a dynamic interface called guestvlan. IP is: 192.168.2.10/24. Under primary DHCP I put the manag...

Hello. When I launch the Google Earth Maps from WCS, there is white overlay that blurs the heat map, any solutions to this??Thanks..

I have version 4.0.81 of the WCS and a WLC2000 series running 4.1.185. The WCS does not see the WLC. Are these versions compatable? Its a private network only the windows server running WCS and the WLC with two AP's. I can ping the WLC from the serve...

Hello , i hace a problem with a wireless network based on 4 WiSM (two in two 6500) and AP1010. AP's get IP from the DHCP and associate to the controller, but after a while, they start sending a syslog message LWAPP-ERROR: "invalid IP header checksum"...

Hello,we use a wlc4402 and several wlan profiles which are activated on different access-points (wlan override).Does anybody know if there is a possibility to see a summary list of the aps on which a certain wlan profile is activated?Best Regards,Tho...

Hi all, first timere here. I'm configuring a WLC4400 and am consoled onto it and have given it an ip address, and now I can ping it but I cannot browse to it to complete the configuration.

I have Cisco Aironet 1200 access point running IOS 12.3(4)JA. This firmware does not have WPA or WPA2 capabilities.The only current offering is a radius server. Will an IOS upgrade give me the capabilites. The proper firmware is difficult to select, ...

I have 2 WiSM's which I plan on placing in 2 geographically dispersed datacenters. I have 2 questions1) Do I setup the 2 WLC's inside the WiSM to be in the same Mobility group to provide redundancy? Is that the best solution?2) What is the best way t...

I want to enable CDP for LWAPP on code 5.0.148.0 so from the switch command prompt I can do a sh cdp nei to see what access points are on what ports.I have three 3750 controllers that are configured via WCS and at one time CDP was enabled on the LWAP...

What information is stored on the LWAP and where on the LWAP can the informataion be found ?What information is stored on the controller?

Hi all,i need an Access Point which can use 5Ghz band as backhaul and 2.4Ghz as access point for clients without the mesh feature.And how about another solution is to use 1200 AP to perform multiple link role (bridge and AP). Example using 802.11a as...

Hi ,All I can not authenticate WLSE Express using external database with AD. I have downloaded the agent to the Domain Controller and install it on AD.At WLSE Express I found log "Error Server 0 RemoteDomainAuth server domain-auth: Agent API encounte...

I've setup my 1130ag like the cisco walkthrough for wpa2 support. When I try to connect with my Thinkpad R60 with XP SP2 (with wpa2 hotfix) or my Acer with Vista, it just keeps popping up the credentials prompt. If I switch to WPA2-PSK, they both wor...

I am not able to access the GUI of the wireless controller - If I console into the wireless controller I can ping the management IP address but if I console into the switch I cannot ping the wireless controller.I think someone may have screwed up the...