Wireless

I have several VISTA/Intel WLAN PC's that cannot connect to the WLAN via a 1230AG AP. It works fine when the OS is XP. I am using LEAP to a Juniper SBR appliance for authentication.The credentials authenticate on the radius server and the authenticat...

Ok, how do I use these exactly? We're running 4.1.185 on the controllers at the moment and 4.2.81.0 on WCS.First with the Voice metrics, I get no data on my 7920 and 7921 phones? And with the Radio Measurements if I attempt to use it with a client, a...

I have a Workgroup Bridge associated to an AP on my wired LAN side of the site.I can ping and browse "from" the Bridge side to the Wired side, but am unable to do the reverse.What's wrong?

I am having extreme difficulty setting up Cisco Aironet 1310 series devices. here is an overview:We have our main network with an ip scheme of 10.1.1.0/24 on one side and an office across the street that is on 10.1.2.0/24. I want to connect these 2 n...

Hello all. I have a video surveillance system that must be able to be viewed on the wireless. It uses multicast and I have configured that appropriately (checked with tac). The response time is bad, camera images/frames per second very slow. So I thi...

I tried to use the upgrade from WCS byt keep getting this error. Resuls from Autonomous AP Migration Reports:START: Detailed logging started at -> 04.04.2008_19.55.50INFO: Telnet to device 10.144.4.102 done.INFO: Privilege level is equal to 15.INFO: ...

Hi all,i have ACS at head office and cisco's aironet APs use it for authenticating clients, now i have a remote branch, vpn is established between HO and branch.can i use WPA2 ent. at Linksys AP, so users at branch could be authenticated by ACS.thank...

We are using two WLCs e several LAPs, a WCS and an ACS radius.The question: it is possible turn off the radio, automatically, and than turn on at determined time?thanx for you support

Hello. We have a remote office that have two parts/rooms. First room has router, switch and some employees PCs second room has remaining PCs ,printers and switch of course. Only way how to connect these rooms was through wirelless. So we have now AP ...

Hi All,I am not able to login into the GUI. It shows only an blank screen in the browser when i try to access the WLSE thorugh the GUI.. But we are still able to connect over SSH to the box and reload it. After the reload the GUI login is working aga...

I cannot seem to find any information as to where the email addresses go that are inputed into the form for accepting guest wireless access to the network. Anyone know where to find this in either the controller or WCS??

Hi all,I have a 4402 and wcs. I'm working in a project to provide public access to web thought 1242AG AP's. I have just one cable of optic fibre/media converter that i can plug ONE AP on the wired network and use the 4402/wcs to control it.The questi...

deari deployed Wireless access points with Two WISM i found some problem when some WorkStations Use (wireess adapter linksys )some Workstations is droped the signal and come On again this is the report from ControllergSystem TimeTrap0Thu Apr 3 15:07:...

Hello, exist an upgrade to enable IPV6 on this AP?. I have denial of service on it. Thanks. Leo.

Hi,I am working on setting up a WLAN for guests to use for Internet access. I set up a WLAN and used a VLAN to seperate it from my prod network. I set up a dynamic interface called guestvlan. IP is: 192.168.2.10/24. Under primary DHCP I put the manag...