Wireless

Hi,With a 4404 WLC, we tried to implement H-REAP using 1242 AP's. The AP's are continuously rebooting without getting registered to the WLC. Please provide me with the implementation document which is other that Document ID :71250 & WLC configuration...

Is there a way to shut down one controller module on a WiSM through WCS?

I have 2 Cisco 1131 Autonomous AP's that I need to configure for wireless roaming. I have 2 VLANs that I plan to broadcast over 2 ssid's. I read up a little on the Cisco site and it states that I need to have a WDS server or an AP with WDS. Is there ...

I am deploying wireless to several buildings and using a wism to manage all of the AP's. I am planning to seperate all of my WLANS from my Wired lans so that each building will have 2 subnets, one for wired and the other for wireless. In the building...

Hi,I have a WLC (4404), and it is configured for authentication in ACS.When I conect in WLC whit browser (HTTPS), I put my username and password from ACS, and it works. However, if I put the local username in WLC it works. I would like to disable the...

Hello allI have gud exp. in wired networking but a WiFi project of such extent is new for me. 1.75 users in 40 rooms with 802.11n NIC's2.10 shall be updating considerable amount of data to server.3.All need excellent bandwidthDid a site survey and ab...

We are deploying 4402 controller ( ver 4.2), and trying to define a WLAN for guest access with web auth.Our VLAN address in the controller is 192.168.20.2 and default gateway is 192.168.20.1 ( which is defined in the core L3 switch.When clients conne...

When I move a Building in WCS 4.19 to a new campus, the access points in the building do not show up on the campus, the campus shows 0 access points. Any ideas?

Have a 3560PoE enabled switch. When we plug a 802.3AF phone in it won't power up but if I plug a Cisco AP point in it will power up the port on the switch. Anyone know whats going on? Command line (port configuration) to fix this?

I have two 1410 bridges, one configured as root and the other as non-root. I upgraded the root bridge and lost communication with the non-root. I tried to upgrade the non-root and I get a polling window that pops up and gives the status as IDLE resta...

Do we have an equipment that can block unwanted Wi-Fi radio signals so that the expected Wireless signals within a room or laboratory in this case will the be the only radio signal that will contain this room. Any other unwanted Wi-Fi radio signal wi...

After extensive conversations with TAC, I have come to discover that you cannot rely upon the system to tell you if a rogue AP is on the network. This is true EVEN WITH AN AP CONFIGURED FOR OPEN AUTHENTICATION. I have tested this in-house with a rogu...

Hi netpro, let me share with you some background first, currently my AP has 3 Radius server which mainly for redundancy, incase Radius server A down, server B will take over. but, lately i noticed when my Server A , Server B never take over and i saw...