Wireless

WLC 2006 work fine for 6 APs on two different location,now I take off one AP and install another new AP on aother WAN segment(DHCP option 43 setting for this AP etc..ok). But this AP restart repeated near every 1 minute.The debug show the this AP 802...

Hello,I had working lab with 4402 controller, 1121G AP and 4.1.185.0 sw.After upgrade to 4.2.61.0 it looks like AP won't load new image, on WLC is a lot of AP Associated / AP Disassociated messages in log. I have tried same thing with 2106 controller...

In optimizing my system, I would like to see the signal strength of various other nodes as heard by the node I am optimizing. The only way I have found to do it is to let it mesh up and then go to WCS or the controller and see what the radio reports ...

I set up the AP1231G a few months ago. All of a sudden, client computer cannot get IP address any more while it can still see and connect to the AP. It looks like something wrong with DHCP but I did not change any setting at all. Before I make a TAC ...

Cannot get more than 40 percent connecion power even when directly under the AP. Using Cisco CB21AG-A-K9 cards in Toshiba M4400 tablet. We set the cards to use the A radio at 5220Mhz CH 4 transmit power of 11dBm The A radio is a Air-RM22A. Do not und...

HiI have a set up where 5 host spots are scattered over one floor..sometimes very close to each other.HPs are connected to a 4506 and from there L2 switches to a VPN concentrator.few users have been drooping on and off the VPN. starting with the swit...

Which interface on the WLC do I have to configure to make a connection from my laptop to the WLC

I am unable to set the web authencation. I have a 4402 and 1130abg I am using the controller's page for auth. No layer 2 auth. The client gets the ip the ssid shows as unsecured. it does not takes me to the auth web page.

I have two questions:We had a passthru authentication page working on our controllers with version 4.1.95.0 and it is not working after the upgrade to 4.2. What changed between releases?How do I generate a CSR for the web authentication page so I can...

I'm trying to setup my 526 WLAN Controller to work with my MS IAS server. I want to be able to have my users authenicate via Radius but I can't seem to get that to work.Under my security I added my radius server IP, and then went under my WLAN and in...

Hi, I wonder if anybody can suggest me a valid solution:I have an IBM thinkpad with an Aironet PCI wireless LAN adapter.It worked fine with my home wireless router for months. Recently It started to have problems: the connection frequently stops (the...

Greetings-I am having an issue with getting machine authentication to work.I have:Windows Server 2003 with AD, certificate services, and IAS installed.Windows XP client - SP2 with WPA MS fixes. Installed machine cert from CA.4400 controller with 4.1x...

Hello there,Just would like to ask if there is a way to shut off the LEDs lights from AP1230 with LWAPP OS.Thanks!Natan.

I received an error message when performing Calibration model to add data points in WCS.MAC is not detected as a client but found on floor.Upon reading over the RF calibration, it was noted that Cisco recommends using the Cisco Aironet 802.11 a/b/g W...

We are trying to use LEAP authentication to get 7920 phone authenticated against the WLC, but its not working, Has anyone seen any caviats with this kind of a setup..