Wireless

I need to add about 160 client MACS for wireless access. What is the quickest way to do this? Add to ACS and then radius the wlc's to point to that list or create the list on each WLC. I ask because I am unaware of any bulk way on the 4404 or 4402.

I recently purchased 2 1300AP's.1.What do I lookup to learn how to roam from AP to AP without dropping the signal.2. Is this AP capable of prompting a user for a user/pass via the browser and still keep the wireless open? I'd like to setup a password...

When I log into our WLC I see a very high TX Failed, ACK Failure, RTS Failure and FCS Error Counts. Is this normal? How can I troubleshoot this problem? We have 10 LAPs that are in the same network as the managed and ap manager interfaces on the WLC....

I have several 1200 G-series Access Points that were already setup and configured before I arrived here and now I want to be able to manage them and at least be able to login and view the config on these.how do I do that?

I just updated to WLSE 2.15.1 so I could use it to push out the 12.3(8)JEC IOS out to all of my 1210 AP's. While setting up the job, the WLSE gives a waring that the IOS I selected may not be for the AP I selected. I have confirmed that the IOS is th...

I understand that it is probably recommended from a security standpoint to ensure "validate server certificate" is checked on each client and that either a self-signed or Trusted CA (Verisign) certificate be employed. Can someone give me an example o...

Howdy,With Aironet client 3.6, it complains that I have no certificates on my computer when I attempt to configure EAP-TLS. As far as I know, I do have certs on my computer. They were created with OpenSSL and appear to comply with the requirements in...

I did my site survey at minimal power and calculated the number of AP's and thier placement. The APs are in and running a power level of 1. According to the Docs that is 100% these AP's are 75 feet apart. The design was at 1mw why would they be runni...

We have 12 7921's at one of our locations that work, but show a Status of Unknown an and IP Address of Unknown in the CallManager Administration page.Does anyone have any ideas about what could be causing this?Cisco Unified CallManager Administration...

I have a New wireless network running with 12 1131's and no controller.The Data works fine, and the voice vlan appears to work.The phone authenticates (7921 running 1.04 tried 1.03 as well same symptom)IT is registered in CCM, It stays up and doesn't...

I have lwapp setup at our main office successfully all on the same ssid/vlan. I have 1 remote off with 2 access points that I would love to convert to lwapp using h-reap. I was hoping this could be done using the same ssid and having auth / dhcp cont...

Hi, Can anyone help to understand how to integrate ASN Gateway with WIMAX RAN.RegardsKas