Wireless

Hi there,I have a custom Webauth page successfully loaded into my 2106 WLC. It is essentially the same as the original page with a few cosmetic tweaks in line with our branding and works seamlessly.What I would like to be able to do is hyperlink a wo...

Problems to access trough web access point console with AAA authentication into ACS Tacacs+ server

Does anybody know if there is a Debug command on the wireless 1240 IOS AP that will basically show what you get with the "show dot11 associations-all"? I'm looking mostly at the client MAC and the Signal strength/SNR values. Thanks

The only way I can figure out how to change the time/date on 1231ap's is through telnet/console. Any way to do so through the web interface?

I have to buy a power supply separately for the Cisco 3270?

I have to create a mobility group for a WLC 2100 and WLC 2006. Do I have to create this group on both controllers or just on one?Thanks...

Hello,I'm in the process of installing a WLC but am having trouble with the internal DHCP server, I am able to associate but am not assigned an IP address, this is the configuration : Client interface :Interface Name.....................................

hello,at the moment i have two 4404-100 controllers. in the backbone we have two 4500 switches. the two 4500's are connected via an 4 gbit channel. for l3 redundancy weuse hsrp. the controllers have the following ip configuration:controller 1: vlan 2...

Hi NetPro,does anyone knows how / what command use for AP setting. which means i want this user only associate with specific AP only. i am using Cisco Aironet 1200 series.your reply will be higly appreciated.regards,Jackal

I have a AIR-LAP1242AG-A-K9 that I need to setup using Autonomous Mode. From what I understand I need software to do this but I didn't get anything with the device. I see the AP gets an IP address but when I try to access it IE does not find it.

Hi,I have an AP1220 configured connected to trunk port on a 2980 switch. On the AP i have it setup like this on the Dot1Radio0 Interface:interface Dot11Radio0 no ip address no ip route-cache ! ssid Internal vlan 7 authentication open guest-mode !But ...

I have two BR1310Gs and two AP1231Gs.The 4 pcs I'm using for testing purposes are all running IE6 (various versions) and can all connect to the APs and funtionality on web interface is fine.However the BR1310Gs are causing problems. On three of the p...

I have 1300 bridges in station root and non-root mode and all the vlans can communicate across it with address assigned. But when a new unit (pc or phone) is attached.....the DHCP broadcast does not get sent across the wireless link to the DHCP serve...