Wireless

When I log into our WLC I see a very high TX Failed, ACK Failure, RTS Failure and FCS Error Counts. Is this normal? How can I troubleshoot this problem? We have 10 LAPs that are in the same network as the managed and ap manager interfaces on the WLC....

I have several 1200 G-series Access Points that were already setup and configured before I arrived here and now I want to be able to manage them and at least be able to login and view the config on these.how do I do that?

I just updated to WLSE 2.15.1 so I could use it to push out the 12.3(8)JEC IOS out to all of my 1210 AP's. While setting up the job, the WLSE gives a waring that the IOS I selected may not be for the AP I selected. I have confirmed that the IOS is th...

I understand that it is probably recommended from a security standpoint to ensure "validate server certificate" is checked on each client and that either a self-signed or Trusted CA (Verisign) certificate be employed. Can someone give me an example o...

Howdy,With Aironet client 3.6, it complains that I have no certificates on my computer when I attempt to configure EAP-TLS. As far as I know, I do have certs on my computer. They were created with OpenSSL and appear to comply with the requirements in...

I did my site survey at minimal power and calculated the number of AP's and thier placement. The APs are in and running a power level of 1. According to the Docs that is 100% these AP's are 75 feet apart. The design was at 1mw why would they be runni...

We have 12 7921's at one of our locations that work, but show a Status of Unknown an and IP Address of Unknown in the CallManager Administration page.Does anyone have any ideas about what could be causing this?Cisco Unified CallManager Administration...

I have a New wireless network running with 12 1131's and no controller.The Data works fine, and the voice vlan appears to work.The phone authenticates (7921 running 1.04 tried 1.03 as well same symptom)IT is registered in CCM, It stays up and doesn't...

I have lwapp setup at our main office successfully all on the same ssid/vlan. I have 1 remote off with 2 access points that I would love to convert to lwapp using h-reap. I was hoping this could be done using the same ssid and having auth / dhcp cont...

Hi, Can anyone help to understand how to integrate ASN Gateway with WIMAX RAN.RegardsKas

Hi,I'm running 4.1.185.0 on a WiSM.From a factory-default config. I had to enter a few commands to get "show wlan 1" indicating WPA2, AES and Auth Key Management=802.1xTwo unexpected thigs:1) The 2nd WLAN I created didn't need any further configurati...

I am attempting to use external web authentication to circumvent the issue of not being able to download custom web page for web auth (I'm using an AireSpace 4012 that will only upgrade to code v3.9 and you need 4.0.x for custom web page download). U...