Wireless

All, I'm in Iraq and I was using the "B" side on at 3 miles away with a solid dish "AIR-ANT3338" and was getting 2meg down on by bandwidth and now I'm lucky to get 400K. I have one root hub and 4 non root hubs linking to it with no more than 6 users ...

hallo i have version 3.2.78 on my wlc 4402 and i want to configure it for EAP-TLS. it should be secured by 802.1x and wpa2 but i dont know how to do it properly over the webinterface. every suggestion is appreciated.

Hello,recently I've installed a Cisco WCS server.In the MAPS section I have added a map (outdoor area) and I have dragged the two access point in the map(1 RAP and one MAP) to see the heat map of the signal.The problem is that for the first 2 days it...

All,I have WiSM rev 4.1.185.0. I try to make some WGBs using LEAP and TKIP together with a client username and password. However, no matter what I do the WGB cannot associate.The documentation I found on this only goes as far as wep, no TKIP/AES and ...

We have an issue with a Fujitsu Siemens Amilo Laptop. It uses 802.1x with dynamic WEP and PEAP-MSCHAP (MS-IAS), Verisign Imported Certificate. It works fine in a Autonomous environment but fails in Unified environment. Other laptops work fine in both...

Hi, I am implementing dot1x with PEAP for wire and wireless access, before I get CA running, I am using ACS server self-signed certificate. However, XP client won't be able to authenticate if I have the "validate server certificate" box checked. I di...

Hi, are these AP ready for sale now, cause I do not find them in the ordering tool?For them to work with 802.11g standard, should I configure the same antenna types used for 1200 series, and is it necessary to place the 6 antennas?

Recently added WPA2 and wlans in our test lab to 350's and now rf units are having issues staying connected and timing out. Logging history reports following message constantly: Interface Dot11Radio0, Deauthenticating Station Reason: Disassociated be...

What do guys thinks between the following product for a site survey:OmnipeekCognioair magnet

I was wondering if anyone has worked with Innerwireless with Cisco LWAPP solution. I want to know if there are any drawback to using innerwireless instead of the normal AP design. Critical applications will be used on this wireless system which will ...

Hello,I'm using AIR-AP1232AG.I did ping test to gateway and the result is not so good like below.What should I do for this?Pinging 10.1.1.1 with 32 bytes of data:Reply from 10.1.1.1: bytes=32 time=1ms TTL=255Reply from 10.1.1.1: bytes=32 time=2ms TTL...

Hi,Is there a way to tell remotely if an antenna has been connected to a specific radio interface (just as you are able to see a serial cable connected to a serial interface) ?Thank You,Dragos