Wireless

We just got our 4402 WLC with 1131ag access points up and running. We would now like to set up guest access with only internet access. Our vendor has suggested setting up a dmz on our checkpoint firewall and have it do dhcp and then setting up a wlan...

I manage a 150-AP wireless network running the 4.0.219 code with WLC 4400 controllers and 1242 AP's . We have a bunch of Dell laptops with Dell branded wireless cards (broadcom chipsets) that will suddenly stop working on our wireless network but wil...

Hey all,I have a strange problem. I just installed a 1242 LWAPP on a 4506 switch. If I set the port to trunk I can't ping the AP and WCS "looses" it. Clients still see the signal, but if I set the switchport to access WCS can see the device and I can...

Hello,We have one cisco876w router and three access-points. We are using a wpa eap authentication. Roamin between the access-points only works fine. Roaming from one access-point to the cisco876w works fine. But roamin from the 876w to a access-point...

I'm looking for help configuring and managing MAC address authentication using the CLI. We are using 1230 model access points running software version 12.3(4)JA. The AP is setup for open authentication with MAC authentication by a local list only. I ...

Hi ,Can anyone help me to configure Juniper Steel belted radius to authenticate cisco access point clients?Model : cisco 1242 AG Radius : Juniper Steel belted radius serverThanks in Advance..RegardsSenthil

Cisco Aironet 1200 Firmware 12.3(8)JEBHello,I want to control client associations when AP load is high.Is there an MIB object that enables/disables client associations?I have searched the supported MIBS, but i could not find anything.

Hi,Following excerpts from WLC 4402 configuration guide ver 4.1WLANs can use web authentication if IPSec or VPN passthrough is not enabled on the controller. Web authentication is simple to set up and use and can be used with SSL to improve the overa...

I buy a Antenna AIR-ANT5160V-R and connect to AP but i can't connect any users to the AP. I have 2 antennas of 2.4bdi and all my users can connect at AP when i install in AP.I need something to configurate into the AP for my new antenna of 6 dbi?

Does anyone know how the "Diagnostic Channel" feature in v4.1 of WLC code can be used to troubleshoot client issues? Once I check the checkbox in the WLAN Advanced properties tab, what are the next steps? Do I need to do anything on the client(s)? Wh...

Hi,I have noticed that with only web authentication, the guest client can send DNS requests through the wireless network and out to the internet via the controller prior to being authenticated.Then, using DNS tunnelling techniques, could surf the web...

I've configured a 2811 ISR with an HWIC-AP-G-A for LEAP w/ RADIUS authentication. I am searching for documentation for configuring PEAP but am having a hard time finding what I am looking for.Could anyone point me in the right direction, and tell me ...